Page 1
PART NO. 5632
2002 GMC YUKON DENALI
FRONT GUARD SET
INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required:
• 1/8” drill bit / Drill
• Center punch / Hammer
• Short Phillips screwdriver
• Marking utensil (fine tip marker, grease pencil, etc.)
NOTE: It may be necessary to remove the wheels depending on the tools being used for installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Hold mud guard to fender and make sure mud guard is level and centered over tire tread.
3. Using mud guard as a template, mark, center punch, and drill 1/8” holes at locations A, B, C, and D.
4. Attach mud guard to fender with #10 screws at locations A, B, C and D.
Package Contents
• Driver & passenger side mud guard
• 1” #10 screws (qty. 8)
• Instruction sheet
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer
5632 Front Instructions.doc
Rev: 0
Loading...