Husky Liners 5602 User Manual

PART NO. 5602

99-02 JEEP GRAND CHEROKEE LIMITED
FRONT MUD GUARD

INSTALLATION INSTRUCTIONS

Please read instructions thoroughly before installation.

Tools Required:

• 1/8” drill bit / Drill

• Center punch / Hammer

• Short Phillips screwdriver

NOTE: Turn the front wheels all the way to the left or right for mud guard installation. However, it may be necessary
to remove the wheels depending on the tools being used for installation.

1. Clean and degrease the mud guard location area on the fender before installation.

2. Remove existing factory fastener from location A (Figure 1).

3. Attach mud guard at location A with factory fastener. Check fit and level before tightening.

4. Using mud guard as a template, center punch, and drill 1/8” holes at locations B & C and fasten with #10 screws.

Package Contents

• Driver (LH) & passenger (RH) side mud guards

• #10 screw (qty. 4)

• Instruction sheet

PAINTING INSTRUCTIONS

1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.

2. Sand painting surface with 320 grit sand paper.

3. Apply a coating of flexible primer-adhesion promoter.

4. Apply a flexible paint as directed by the paint manufacturer

5602 Front Instructions.doc

Rev: 1