Page 1
PART NO. 5445
5445 H2 front Flat In#F79F9.doc
Rev: 0
HUMMER H2
FRONT MUD GUARDS
INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required
• Short Phillips screwdriver
• Center punch / Hammer
• Drill / 1/8” drill bit
Package Contents
• Driver (LH) & passenger (RH) side front mud guard
• 1” #10 screw (qty. 6)
• Washer (qty. 6)
• U-Clips (qty. 2)
• Instruction sheet
NOTE: Turn the wheels all the way one way or the other for installation. It may still be necessary to remove the wheels depending
on the tools being used.
1. Clean the mud guard location area on the fender before installation.
2. Remove existing fastener from location B (Fig. 1).
3. Place mud guard against front fender and install factory fastener at location B, make sure bottom edge of mud guard is parallel
to ground before tightening.
4. Using mud guard as a template, mark and drill an 1/8” hole at locations A and C and fasten with a 1” #10 screw and washer.
5. Mark and drill 1/8” hole at location D. Attach with a 1” #10 screw and washer through mud guard and liner and into U-clip on
the backside of liner. NOTE: The u-clip is used like a nut and not to be clipped over liner.
NEED A LOGO FOR YOUR NEW MUD GUARD? TRY AN INTERNET SEARCH FOR
“EMBLEM” ON E-BAY, AMAZON OR YOUR FAVORITE AUTOMOTIVE SITE.
Loading...