Page 1
PART NO. 5439
5439 Old Chevy Dual #F7AF6.doc
Rev: 0
GMC/CHEVROLET DUALLY LOGO READY REAR MUD GUARD
INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required
• Short Phillips screwdriver
• Center punch
• Drill / 1/8” drill bit
• 13 mm wrench
Package Contents
• Driver & passenger side rear mud guard
• #10 screw (qty. 6)
• Washer (qty. 6)
• Instruction sheet
NOTE: It may be necessary to remove the rear wheels depending on the tools being used for installation.
1. Clean the mud guard location area on the fender before installation.
2. Remove existing bracket fastener from locations D using a 13 mm wrench or socket (Figure 1).
3. Attach mud guard by installing an existing bracket fastener at location D - through mud guard, fender, and into fender
bracket (Figures 1 and 2).
4. Using mud guard as a template, center punch and drill 1/8” holes at locations A, B, and, C (Figure 1).
5. Install #10 screws and washers at locations A, B, and C.
NEED A LOGO FOR YOUR NEW MUD GUARD? TRY AN INTERNET SEARCH FOR
“EMBLEM” ON E-BAY, AMAZON OR YOUR FAVORITE AUTOMOTIVE SITE.
Loading...