Page 1
PART NO. 5435
5435 Dodge Mega Cab D#F7ABA.doc
Rev: 0
DODGE MEGA CAB DUALLY REAR MUD GUARD
INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required
• 1/8” drill bit / Drill
• Center punch / Hammer
• Short Phillips screwdriver or drill attachment
Package Contents
• Driver & passenger side rear mud guard
• #10 screw (8)
• Washers (8)
• U-clip (4)
• Instruction sheet
NOTE: It may be necessary to remove the wheels depending on the tools being used for installation.
1. Remove existing fasteners from location A and C (Figure 1).
2. Install mud guard to rear fender with #10 screws and washers at locations A and C (Figure 1). Check fit and parallel and
adjust accordingly before tightening.
3. Using mud guard as a template, mark and drill 1/8” holes at locations B and D.
4. Install u-clip over fender at location B and fasten with a #10 screw and washer thru mud guard and into fender and u-clip.
5. Install #10 screw and washer at location D, thru mud guard, fender liner and into a U-clip placed on the backside of fender
liner (Figure 2).
NEED A LOGO FOR YOUR NEW MUD GUARD? TRY AN INTERNET SEARCH FOR
“EMBLEM” ON E-BAY, AMAZON OR YOUR FAVORITE AUTOMOTIVE SITE.
Loading...