PART NO. 5433
5433 Installation Ins#F7A9A.doc
Rev: 0
DODGE RAM
FRONT & REAR LOGO READY MUD GUARDS - INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required:
• 1/8” drill bit / Drill
• Center punch / Hammer
• Short Phillips screwdriver or drill attachment
• Marking utensil (fine tip marker, grease pencil, etc.)
Package Contents
• Driver & passenger side mud guard
• #10 screw (qty. 8)
• U-clip (qty. 4)
• Washers (qty. 8)
• Instruction sheet (front & rear)
FRONT & REAR MUD GUARD INSTALLATION
NOTE: Turn the front wheels all the way to the left or right for mud guard installation. However, it may be necessary
to remove the wheels depending on the tools being used for installation.
1. Clean the mud guard location area on the fender before installation.
2. Using the mud guard as a template, position and mark hole location B with a marking utensil. Make sure the mud guard
fits flush against the front fender and is parallel to the ground (figure 1).
3. Center punch and drill 1/8” hole at location B.
4. Attach mud guard to front panel with #10 screw, check fit and alignment. Adjust accordingly.
5. Center punch and drill 1/8” holes at locations A, C and D using the mud guard as a template.
6. Install #10 screws at locations A, C and D, check fit and tighten.
REAR MUD GUARD INSTALLATION
NOTE: It may be necessary to remove the rear wheels depending on the tools being used for installation.
7. Clean the mud guard location area on the rear panel before installation.
8. Remove existing fasteners (either plastic rivets or factory sheet metal screws) from locations B and D (see figure 2). If
vehicle has factory sheet metal screws in locations B and D, remove and save for reuse (SKIP STEP 9). If fasteners are
plastic rivets, break to remove and discard.
9. Pull liner out and install U-clips over liner at locations B and D (see figure 3), return liner to original position.
10. Attach mud guard to rear panel with #10 screws or existing factory sheet metal screws at locations B and D.
11. Center punch and drill 1/8” hole at locations A and C using the mud guard as a template.
12. Install #10 screws at locations A and C, check fit and tighten.
NEED A LOGO FOR YOUR NEW MUD GUARD? TRY AN INTERNET SEARCH FOR
“EMBLEM” ON E-BAY, AMAZON OR YOUR FAVORITE AUTOMOTIVE SITE.
Loading...