Page 1
PART NO. 5428
5428_Installation Ins#F7A8B.doc
Rev: 0
FORD F-150 REGULAR CAB/SUPER CAB & CREW CAB TRUCKS WITH FACTORY FLARES AND
LINCOLN MARK LT—LOGO READY REAR MUD GUARDS
REAR MUD GUARDS
Please read instructions thoroughly before installation.
Tools Required
• 1/8” drill bit / Drill
• Short #2 Phillips screwdriver
• Center punch
Package Contents
• Driver & passenger side rear mud guard
• #10 screw (qty. 8)
• Washers (qty. 8)
• U-Clip (qty. 2)
• Instruction sheet
NOTE: It may be necessary to remove the rear wheels for mud guard installation.
1. Clean the mud guard location area on the fender before installation.
2. Remove factory fastener from locations B and place a U-clip over sheet metal and align fastener holes (Figure 3. 3.
Attach mud guard with a #10 screw and washer at location B, check fit and make sure the mud guard is parallel to
the ground before tightening.
4. Using the mud guard as a template, center punch and drill an 1/8” hole at location A, C, and D (Figure 1).
5. Install #10 screws and washers at location A, C, and D.
NEED A LOGO FOR YOUR NEW MUD GUARD? TRY AN INTERNET SEARCH FOR
“EMBLEM” ON E-BAY, AMAZON OR YOUR FAVORITE AUTOMOTIVE SITE.
Loading...