Husky Liners 54201 User Manual

PART NO. 5420

5420_Installation Ins#F7A06.doc

Rev: 0

CADILLAC ESCALADE & YUKON DENALI LOGO READY REAR MUD GUARDS

INSTALLATION INSTRUCTIONS

Please read instructions thoroughly before installation.

Tools Required

• 1/8” drill bit / Drill

• Center punch / Hammer

• Short Phillips screwdriver or drill attachment

Package Contents

• Driver & passenger side rear mud guard

• #10 screw (8)

• Washers (8)

• U-clip (8)

• Instruction sheet

NOTE: It may be necessary to remove the wheels depending on the tools being used for installation.

1. Remove existing fastener and u-clip from location A and plastic fastener from location C (Figure 1).

2. Install mud guard to rear fender at location A using provided u-clip, washer and #10 screw (Figure 1). Check fit and parallel
and adjust accordingly before tightening.

3. Install a u-clip, washer and #10 screw at location C.

4. Using mud guard as a template, mark and drill 1/8” holes at locations B and D.

5. Install #10 screw and washer at location D, thru mud guard, fender liner and into a U-clip placed on the backside of fender
liner (figure 2).

6. Install #10 screw and washer at location B, thru mud guard, fender and into a U-clip placed on the backside of fender.

NEED A LOGO FOR YOUR NEW MUD GUARD? TRY AN INTERNET SEARCH FOR
“EMBLEM” ON E-BAY, AMAZON OR YOUR FAVORITE AUTOMOTIVE SITE.