Husky Liners 54031 User Manual

PART NO. 5403

5403 Chevy Dual Flat #11700.doc

Rev: 0

GMC/CHEVROLET DUAL REAR FLAT MUD GUARD

INSTALLATION INSTRUCTIONS

Please read instructions thoroughly before installation.

Tools Required

• Short Phillips screwdriver

• Center punch

• Drill / 1/8” drill bit

• 13 mm wrench

Package Contents

• Driver & passenger side rear mud guard

• #10 screw (qty. 6)

• Washer (qty. 6)

• Instruction sheet

NOTE: It may be necessary to remove the rear wheels depending on the tools being used for installation.

1. Clean and degrease the mud guard location area on the fender before installation.

2. Remove existing bracket fastener from locations D using a 13 mm wrench or socket (Figure 1).

3. Attach mud guard by installing an existing bracket fastener at location D - through mud guard, fender, and into fender
bracket (Figures 1 and 2).

4. Using mud guard as a template, center punch and drill 1/8” holes at locations A, B, and, C (Figure 1).

5. Install #10 screws and washers at locations A, B, and C.