Page 1
3583.doc
11/17/2004
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of
your factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your
new floor liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work
well. Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR LEXUS
RX-300/RX-330 AND TOYOTA HIGHLANDER FRONT LINERS
TO INSURE THE PROPER FIT OF YOUR DRIVER’S SIDE LINER, PLEASE REMOVE THE FACTORY
INSTALLED CARPET HOOK(S). THE HOOK(S) CAN BE EASILY REMOVED BY GENTLY PULLING THE
HOOK UP AND BACK TOWARD THE MOUNTING HOLE. THIS WILL ALLOW THE HOOKS TO “POP” OUT.
SIMPLY STORE THE REMOVED HOOKS IN YOUR GLOVE BOX OR CONSOLE SHOULD YOU NEED TO
REPLACE THEM AT A LATER DATE.
IF YOUR VEHICLE IS EQUIPPED WITH A FLOOR MOUNTED FUEL DOOR RELEASE LEVER, YOUR LINER
CAN EASILY BE TRIMMED TO ALLOW ACCESS TO THE LEVER. JUST TRIM AWAY THE MATERIAL FROM
THE AREA SHOWN ABOVE DARKENED (SEE CIRCLED AREA). THE TRIM AREA IS SLIGHTLY RECESSED
TO PROVIDE A TRIMMING GUIDE. TO TRIM, USE A UTILITY KNIFE OR SIMILAR ITEM. AS ALWAYS,
WHEN USING A SHARP ITEM TAKE CAUTION TO AVOID INJURY.
LEFT OR
DRIVER’S
SIDE LINER
RIGHT OR
PASSENGER’S
SIDE LINER
Loading...