3402.doc
12/22/2004
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liners are custom molded to fit your particular vehicle. The liners are made to take the
place of your factory floor mats. For correct fit, it is necessary to remove the factory floor mats before
installing your new floor liner . However, do not remove the factory-installed carpeting.
Your liners are made from an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liners is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work
well. Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liners slick.
INSTALLATION INSTRUCTIONS FOR YOUR SUBARU
OUTBACK/LEGACY
LEFT OR
DRIVER’S
SIDE
RIGHT OR
PASSENGER’S
SIDE
WHEN INSTALLING YOUR DRIVER’S SIDE LINER, MAKE SURE THAT THE FACTORY CARPET HOOK IS
POSITIONED WITH THE HOOK END TOWARDS THE FIREWALL (SEE PHOTO ON BACK SIDE).
TO ALLOW ACCESS TO THE FUEL DOOR RELEASE LEVER WITH YOUR LINER IN PLACE, SIMPLY
TRIM AWAY THE MATERIAL FROM THE LOWERED AREA ON YOUR DRIVER’S SIDE LINER (AREA
SHOWN DARKENED ABOVE). A UTILITY KNIFE WORKS WELL FOR TRIMMING. YOU CAN AVOID
TRIMMING BY JUST LIFTING THE LINER UP TO ACCESS THE RELEASE LEVER.
3402.doc
12/22/2004
CARPET HOOK SHOWN ORIENTED CORRECTLY. IF YOUR HOOK IS
NOT SITUATED AS SHOWN, SIMPLY TURN IT TO THIS POSITION.
Loading...