Husky Liners 3110 User Manual

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of
your factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new
floor liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The

easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work
well. Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.

INSTALLATION INSTRUCTIONS FOR YOUR CHEVROLET

AND GMC TRUCKS AND SPORT UTILITY VEHICLES

LEFT OR

DRIVER’S SIDE

IF YOUR VEHICLE IS EQUIPPED WITH A MANUAL TRANSFER CASE SHIFTER, YOU WILL NEED
TO TRIM YOUR DRIVER’S SIDE LINER AS SHOWN ABOVE. TRIM AWAY THE RECESSED
PORTION ON THE LINER WALL. SOME CREW CAB MODELS MAY REQUIRE THE RAISED AREA
SHOWN DARKENED ON THE PASSENGER’S SIDE LINER TO BE TRIMMED AWAY TO ALLOW
PROPER FIT. A UTILITY KNIFE OR HEAVY SCISSORS WORKS WELL FOR TRIMMING.

RIGHT OR

PASSENGER’S SIDE

3110.DOC
Rev: 0

01/31/01