Page 1
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely unroll and
lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your vehicle with a weight in each
corner (a book works well). After about 15 minutes, your liner will remain flat. In colder climates this “relaxing” may take
longer; moving the liner to a heated area will accelerate the process.
Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable. The easiest way
to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of Armor All®, Sonof-a-Gun® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR MITSUBISHI MONTERO
CARGO LINER
TO ACCESS THE FACTORY CARGO HOOK TIE DOWN LOCATIONS WITH YOUR CARGO
LINER IN PLACE YOU MUST FIRST TRIM AWAY THE MATERIAL INSIDE THE FOUR (4)
RECESSED AREAS ON YOUR LINER (SHOWN DARKENED). TO ACCESS THE THIRD POINT
CHILD SEAT TETHERING ANCHOR, TRIM OFF THE CORRESPONDING RAISED AREA
SHOWN CIRCLED ABOVE.
2850.DOC
Rev: 0
01/31/01
Loading...