Husky Liners 2810 User Manual

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely unroll
and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your vehicle with a
weight in each corner (a book works well). After about 15 minutes, your liner will remain flat. In colder climates this
“relaxing” may take longer; moving the liner to a heated area will accelerate the process.
Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable. The easiest

way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of Armor
All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.

INSTALLATION INSTRUCTIONS FOR YOUR MITSUBISHI

MONTERO CARGO LINER

TO ACCESS THE FACTORY CARGO HOOK TIE
DOWN LOCATIONS WITH YOUR CARGO LINER
IN PLACE YOU MUST FIRST MAKE A SLIT IN
THE FOUR (4) RAISED AREAS ON YOUR LINER
(SHOWN CIRCLED). THEN, PUSH THE HOOK
RINGS UP THROUGH THE LINER.

TO ACCESS THE REAR SEAT ATTACHMENT POINTS
WITH YOUR LINER IN PLACE, TRIM OUT THE AREAS
INSIDE OF THE RAISED BANDS (SHOWN ABOVE
HATCHED). A UTILITY KNIFE WORKS WELL.

2810.DOC
Rev: 0

01/31/01