Husky Liners 2790 User Manual

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely unroll
and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your vehicle with a
weight in each corner (a book works well). After about 15 minutes, your liner will remain flat. In colder climates this
“relaxing” may take longer; moving the liner to a heated area will accelerate the process.
Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable. The easiest

way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of Armor
All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.

INSTALLATION INSTRUCTIONS FOR YOUR HYUNDAI

SANTA FE CARGO LINER

TO ACCESS THE FACTORY THIRD POINT
CHILD SAFETY SEAT TETHERING ANCHOR,
TRIM AWAY THE CORRESPONDING RAISED
AREA SHOWN DARKENED ABOVE. (SEE
PHOTO ON BACK.

ACCESSING THE FACTORY CARGO HOOK TIE-DOWN LOCATIONS IN YOUR SANTA FE
WITH YOUR HUSKY CARGO LINER INSTALLED CAN EASILY BE ACCOMPLISHED. THE
FORWARD HOOKS CAN BE ACCESSED BETWEEN THE LINER AND THE VEHICLE WALL.
THE REAR HOOKS ARE LOCATED UNDER THE TWO RAISED AREAS LOCATED SHOWN
ABOVE CIRCLED. YOU WILL NEED TO TRIM AWAY THE TOP PORTION OF THESE TWO
AREAS USING A UTILITY KNIFE (SEE PHOTOS ON BACK).

2790.DOC
Rev: 0

12/19/00