Husky Liners 2651 User Manual

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of
your factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new
floor liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The

easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work
well. Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.

INSTALLATION INSTRUCTIONS FOR YOUR

NISSAN XTERRA CARGO LINER

TO ACCESS THE FACTORY CHILD SAFETY SEAT
ANCHORAGES LOCATED ON THE CARGO FLOOR YOU
WILL NEED TO TRIM AWAY THE MATERIAL FROM THE
CORRESPONDING LOWERED AREA IN YOUR LINER
(TRIM UP TO 3 PLACES AS NEED). A UTILITY KNIFE
WORKS WELL FOR TRIMMING.

TO ACCESS THE FACTORY CARGO TIE-DOWN HOOKS IN
YOUR XTERRA WITH YOUR HUSKY LINER IN PLACE,
YOU MUST MAKE A SLIT THROUGH THE CENTER OF THE
AREAS SHOWN HERE CIRCLED (THEY ARE RAISED ON
THE ACTUAL LINER). ONCE SLIT; PULL THE HOOKS UP
THROUGH THE LINER. A UTILITY KNIFE WORKS WELL

2651.DOC
Rev: 1

01/31/01