Husky Liners 2628 User Manual

2628_Insert.doc

04/29/2005

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your

factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor

liner. However, do not remove the factory-installed carpeting.

Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest way

to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of Armor

All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.

INSTALLATION INSTRUCTIONS FOR YOUR NISSAN XTERRA

CARGO LINER

IF YOUR XTERRA IS EQUIPPED WITH THE UTILI-TRACK CARGO CHANNEL SYSTEM, YOU CAN ACCESS
THIS OPTION WITH YOUR CARGO LINER IN PLACE. HERE’S HOW:

FIRST, NOTE THAT YOUR CARGO LINER HAS A MOLDED IN RIB THAT COMPLETELY SURROUNDS THE
AREA ABOVE EACH TRACK. SIMPLY TRIM THE TREAD PLATED MATERIAL (SHOWN ABOVE
DARKENED) FROM THE BOTTOM OF EACH OF THESE “MOATS” AND THEN INSTALL YOUR CARGO
LINER. THE MOATS WILL SURROUND THE TRACKS AND PREVENT LIQUID FROM RUNNING UNDER THE
LINER. A PHOTO OF THE TRIMMED PART IS SHOWN ON THE BACK OF THIS PAGE.

XTERRA’S COME EQUIPPED WITH SMALL CARGO NET THAT IS LOCATED DIRECTLY BEHIND THE
DRIVER’S SIDE WHEEL WELL. YOU CAN ACCESS THE TWO (2) CARGO NET ANCHORS WITH YOUR
LINER IN PLACE (AREAS SHOWN ABOVE CIRCLED). TO DO SO, SIMPLY REMOVE THE MATERIAL FROM
TWO LOWERED “U-SHAPED” AREAS IN FRONT OF THESE ANCHORS. A UTILITY KNIFE OR HEAVY
SHEARS WORKS WELL FOR TRIMMING.

2628_Insert.doc

04/29/2005

XTERRA CARGO LINER SHOWN TRIMMED FOR ACCESS TO UTILI-TRACK

CARGO CHANNEL SYSTEM