Husky Liners 2625 User Manual

2625.doc

12/08/2004

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely

unroll and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your vehicle

with a weight in each corner (a book works well). After about 15 minutes, your liner will remain flat. In colder

climates this “relaxing” may take longer; moving the liner inside will speed up the process.

Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable. The

easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use

of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.

INSTALLATION INSTRUCTIONS FOR YOUR NISSAN

PATHFINDER CARGO LINER

FRONT OF VEHICLE

TO ACCESS THE SIX CARGO TIE-DOWN HOOKS LOCATED IN
YOUR PATHFINDER WITH YOUR LINER IN PLACE, SIMPLY
TRIM AWAY THE MATERIAL FROM AREAS LOCATED ABOVE
THE CARGO TIE-DOWN HOOKS. THESE SIX AREAS (SHOWN
HERE CIRCLED) ARE LOWERED IN THE PART TO AID IN
IDENTIFICATION.

PATHFINDER SE AND SE SPORT MODELS EQUIPPED WITH THE
“EASY CLEAN” CARGO FLOOR DO NOT HAVE CARPETING IN
THE CARGO AREA. TO AID IN SECURING THE CARGO LINER IN
PLACE IN THESE VEHICLES, WE HAVE INCLUDED VELCRO®
DISCS TO ANCHOR THE LINER. TO UTILIZE THE VELCRO®
DISCS, FIRST LET YOUR CARGO LINER “RELAX” UNTIL IT
LAYS FLAT. THEN, INSTALL ONE “HALF” OF THE VELCRO
(HOOK OR LOOP DISC) TO THE CARGO FLOOR, IDEALLY
SPACING IT EVENLY FRONT/BACK/SIDE/SIDE AND BETWEEN
THE RAISED SKID BARS. LET THE VELCRO DISC SET FOR A
COUPLE OF HOURS TO ALLOW THE GLUE TO “SET” BEFORE
CONTINUING. YOU CAN SAFELY REMOVE THE DISCS AT A
LATER DATE IF NEEDED. ONCE THE DISCS HAVE “SET-UP”,
APPLY THE OPPOSING VELCRO® HOOK/LOOP DISC TO THE
FOUR ALREADY POSITIONED DISCS WITH BACKING STILL IN
PLACE. NEXT, POSITION LINER IN VEHICLE AND, WORKING
AT EACH DISC LOCATION INDIVIDUALLY, PULL BACK THE
LINER AND REMOVE BACKING FROM VELCRO® DISC. SECURE
TO LINER BY FIRMLY PRESSING IN PLACE. ONCE THIS IS
COMPLETED IN ALL FOUR LOCATIONS, ALLOW THE LINER TO
SET OVERNIGHT BEFORE LOADING.