Husky Liners 2590FR User Manual

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely
unroll and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your vehicle
with a weight in each corner (a book works well). After about 15 minutes, your liner will remain flat. In colder
climates this “relaxing” may take longer; moving the liner to a heated area will accelerate the process.
Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable. The

easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use
of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.

INSTALLATION INSTRUCTIONS FOR YOUR TOYOTA

RAV4 CARGO LINER

TO ACCESS THE FACTORY CHILD SAFETY SEAT TETHER POINTS,
TRIM AWAY THE MATERIAL FROM THE CORRESPONDING
RAISED AREA SHOWN CIRCLED ABOVE. TWO OF THE CARGO
TIE DOWN HOOKS ARE ALSO USED FOR TETHERING POINTS. A
UTILITY KNIFE WORKS WELL FOR TRIMMING.

TO ACCESS THE FACTORY CARGO TIE DOWN HOOKS WITH YOUR LINER IN PLACE, MAKE A
SLIT ACROSS THE FOUR RAISED AREAS ON YOUR LINER (SHOWN ABOVE COMPLETELY
DARKENED). THEN, PUSH THE HOOKS UP THROUGH THE SLIT AS SHOWN ON THE PHOTOS
ON THE BACK OF THIS PAGE.

2590FR~1.DOC

Rev: 0

12/19/00

RAV4 CARGO LINER PHOTOS SHOWING ACCESS TO CARGO TIE-DOWN HOOKS

PUSHED THROUGH TO ALLOW ACCESS

CHILD SAFETY SEAT TETHERING POINT

AND CHILD SAFETY SEAT TETHERING POINTS

SHOWING LINER SLIT AND TIE-DOWN HOOK

SHOWING RAISED AREA IN LINER TRIMMED

AWAY TO ALLOW ACCESS TO TIE-DOWN HOOK

SHOWING CENTER RAISED AREA IN LINER

TRIMMED AWAY TO ALLOW ACCESS TO THE

2590FR~1.DOC

Rev: 0

12/19/00