Husky Liners 2550 User Manual

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

CIRCLED). THEN, PUSH THE HOOK RINGS UP THROUGH THE LINER.

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely unroll and lay flat. This is
normal and only temporary. Just place the liner on the floor or in the back of your vehicle with a weight in each corner (a book works well).
After about 15 minutes, your liner will remain flat. In colder climates this “relaxing” may take longer; moving the liner to a heated area will
accelerate the process.
Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable. The easiest way to clean your

liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of Armor All®, Son-of-a-Gun® or similar
items is discouraged as these products make the liner slick.

INSTALLATION INSTRUCTIONS FOR YOUR TOYOTA

LANDCRUISER/LEXUS LX-450 CARGO LINER

TO ACCESS THE REAR SEAT ATTACHMENT POINTS
WITH YOUR LINER IN PLACE, TRIM OUT THE AREAS
INSIDE OF THE RAISED BANDS (SHOWN ABOVE
HATCHED). A UTILITY KNIFE WORKS WELL.

TO ACCESS THE FACTORY CARGO HOOK TIE DOWN LOCATIONS WITH YOUR CARGO LINER IN
PLACE YOU MUST FIRST MAKE A SLIT IN THE FOUR (4) RAISED AREAS ON YOUR LINER (SHOWN

2550.DOC
Rev: 0

01/10/01