Husky Liners 2380 User Manual

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of
your factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your
new floor liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The

easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work
well. Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner

slick.

INSTALLATION INSTRUCTIONS FOR YOUR FORD

EXCURSION FULL SIZE CARGO LINER

TRIM OUT THE MATERIAL INSIDE OF THE RAISED BANDS
(SHOWN CROSSHATCHED) TO ALLOW INSTALLATION OF
THE THIRD SEAT. A UTILITY KNIFE WORKS WELL.

TO UTILIZE THE CARGO TIE-DOWN HOOKS IN YOUR
VEHICLE, YOU MUST MAKE A SLIT VERTICALLY
THROUGH THE CENTERS OF THE FOUR (4) RAISED ACCESS
AREAS ON YOUR MAT (SHOWN HERE DARKENED) THEN
PUSH THE HOOKS THROUGH THE SLITS.

2380.DOC
Rev: 0

01/31/01