Page 1
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
LINER, REPLACE YOUR SPARE TIRE. A UTILITY KNIFE WORKS WELL
FOR TRIMMING.
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely
unroll and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your vehicle
with a weight in each corner (a book works well). After about 15 minutes, your liner will remain flat. In colder
climates this “relaxing” may take longer; moving the liner into a heated area will accelerate the process.
Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use
of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR FORD
BRONCO CARGO LINER
IF YOUR BRONCO HAS AN INSIDE MOUNTED SPARE TIRE, YOU MUST
REMOVE THE SPARE BEFORE INSTALLATION OF YOUR LINER. THEN,
NOTICE THE RAISED OVAL LOCATED ALONG THE LOWER RIGHT
HAND EDGE OF YOUR LINER (SHOWN HERE DARKENED). REMOVE
THE MATERIAL FROM THE OVAL LEAVING A 1/8 INCH BORDER. THIS
WILL ALLOW THE LINER TO ACCOMMODATE THE MOUNTING
BRACKET FOR THE SPARE TIRE. ONCE YOU HAVE INSTALLED THE
2320.DOC
Rev: 0
01/31/01
Loading...