Page 1
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely
unroll and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your vehicle
with a weight in each corner (a book works well). After about 15 minutes, your liner will remain flat. In colder
climates this “relaxing” may take longer; moving the liner inside will speed up the process.
Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use
of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR FORD
ESCAPE/MAZDA TRIBUTE CARGO LINER
TO ACCESS THE FACTORY CARGO TIE-DOWN
HOOKS WITH YOUR LINER IN PLACE, MAKE
A VERTICAL SLIT ACROSS THE TOP OF THE
FOUR (4) RAISED AREAS SHOWN HERE
CIRCLED. THEN PUSH/PULL THE HOOKS UP
THROUGH THE LINER.
IF YOUR FORD ESCAPE/MAZDA TRIBUTE COMES EQUIPPED WITH THE FACTORY SIX DISC
IN-DASH CD PLAYER, IT HAS A SUBWOOFER MOUNTED IN THE LOWER LEFT HAND SIDE OF
THE CARGO AREA. YOUR CARGO LINER CAN EASILY BE TRIMMED TO ACCOMMODATE
THIS FEATURE. TO TRIM, CUT ALONG THE OUTER EDGE OF THE MOLDED STEP AND ALONG
THE EDGE OF THE TREAD ON THE RAISED PORTION OF THE LINER. THIS WILL LEAVE A _”
LIP ALONG THE TRIMMED EDGE (SEE ABOVE). PHOTOS OF THE TRIMMED PART ARE
INCLUDED ON THE BACK OF THIS INSTRUCTION SHEET.
2315FR~1.DOC
Rev: 0
01/31/01
Page 2
PHOTOS OF 2315 TRIMMED FOR REAR SUBWOOFER
SHAPED” AREA LOCATED DIRECTLY IN FRONT OF THE POWER POINT.
YOU CAN EASILY ACCESS THE FACTORY POWER POINT LOCATED IN THE
CARGO AREA WITH YOUR LINER INSTALLED. USING A UTILITY KNIFE OR
HEAVY SHEARS, SIMPLY TRIM THE MATERIAL FROM THE RECESSED “U-
2315FR~1.DOC
Rev: 0
01/31/01
Loading...