Page 1
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
TO ACCESS THE FACTORY CARGO HOOK TIE
DOWN LOCATIONS IN YOUR HUSKY CARGO
LINER, YOU MUST FIRST MAKE A SLIT ACROSS
THE TWO (2) RAISED AREAS ON YOUR LINER
(SHOWN HERE DARKENED). THEN, PUSH THE
HOOK RINGS UP THROUGH THE LINER.
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely
unroll and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your vehicle
with a weight in each corner (a book works well). After about 15 minutes, your liner will remain flat. In colder
climates this “relaxing” may take longer; moving the liner to a heated area will accelerate the process.
Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use
of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR CHEVROLET
SUBURBAN/GMC YUKON XL
TO USE THE FACTORY THIRD SEAT WITH
YOUR CARGO LINER IN PLACE, TRIM OUT
THE MATERIAL FROM INSIDE OF THE RAISED
BANDS (5 PLACES--SHOWN HERE HATCHED).
THIS WILL ALLOW ACCESS TO THE SEAT
MOUNTING POINTS
2270.DOC
Rev: 0
01/31/01
Loading...