Page 1
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely
unroll and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your vehicle
with a weight in each corner (a book works well). After about 15 minutes, your liner will remain flat. In colder
climates this “relaxing” may take longer; moving the liner inside will speed up the process.
Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well.
Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR
BLAZER/BRAVADA/ENVOY/JIMMY CARGO LINER
TO ACCESS THE FACTORY CARGO TIE-DOWN
HOOKS WITH YOUR LINER IN PLACE, MAKE A IN
SLIT THE FOUR RAISED AREAS ON YOUR LINER
(SHOWN HERE DARKENED). THEN, PULL THE
HOOKS UP THROUGH THE SLIT IN THE LINER
ENVOY OWNERS AND OWNERS WHOSE VEHICLE IS EQUIPPED WITH THE “ON STAR®” OPTION WILL
NEED TO TRIM THEIR LINER AS SHOWN ABOVE, REMOVING THE OUTER RIGHT PORTION. TRIM
ALONG THE GROOVE IN THE RAISED RIDGE AS SHOWN. A UTILITY KNIFE OR SCISSORS WORK
WELL.
2231.DOC
Rev: 0
01/31/01
Loading...