THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not
completely unroll and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back
of your vehicle with a weight in each corner (a book works well). After about 15 minutes, your liner will remain
flat. In colder climates this “relaxing” may take longer; moving the liner inside will speed up the process.
Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable.
The easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work
well. Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR DODGE
DURANGO CARGO LINER
IF YOUR DURANGO IS A 2001 OR NEWER MODEL, YOUR HUSKY LINER WILL NEED TO BE
TRIMMED BEFORE INSTALLATION. THIS IS EASILY DONE USING A UTILITY KNIFE OR HEAVY
SCISSORS. JUST TRIM AS SHOWN ABOVE, USING THE EDGE OF THE RECESSED STEP AS A
GUIDE (SEE PHOTOS ON BACK). YOUR LINER IS NOW READY FOR INSTALLATION. IF YOU
WOULD LIKE TO ACCESS THE FACTORY CARGO TIE DOWN HOOKS WITH YOUR LINER IN
PLACE, MAKE A HORIZONTAL SLIT ACROSS THE CENTER OF THE RAISED AREAS SHOWN HERE
CIRCLED AND PULL THE HOOKS UP THROUGH THE LINER.
2179FR~1.DOC
Rev: 0
10/18/00
PHOTO OF 2179 TRIMMED FOR USE IN A 2001 DURANGO
2179FR~1.DOC
Rev: 0
10/18/00
Loading...