Husky Liners 21771 User Manual
2177.doc
05/19/2004
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely
unroll and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your
vehicle with a weight in each corner (a book works well). After about 15 minutes, your liner will remain flat. In
colder climates this “relaxing” may take longer; moving the liner inside will speed up the process.
Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well.
Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR JEEP WRANGLER
UNLIMITED CARGO LINER
TO ACCESS THE FACTORY CHILD SEAT SAFETY RESTRAINT ANCHORS, TRIM AWAY THE
MATERIAL FROM THE TOPS OF THE TWO (2) RAISED AREAS (SHOWN ABOVE DARKENED).
NOTE: TO ACCESS THE REAR SEAT
SEAT BELTS, PULL THEM UP
THROUGH THE HOLE PROVIDED IN
RAISED AREA (SEE AREA “1” BELOW).
NOTE: TO ACCESS THE FACTORY CARGO TIEDOWN HOOKS WITH YOUR LINER IN PLACE, YOU
MUST TRIM AWAY THE MATERIAL FROM THE
TOPS OF THE 6 CARGO TIE-DOWN AREAS (SHOWN
CIRCLED). THESE AREAS ARE RAISED SLIGHTLY
ABOVE THE SURFACE OF THE LINER.
1
Loading...