THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely
unroll and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your
vehicle with a weight in each corner (a book works well). After about 15 minutes, your liner will remain flat. In
colder climates this “relaxing” may take longer; moving the liner inside will speed up the process.
Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well.
Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR HUMMER H2 CARGO
LINER (WITH INSIDE SPARE REMOVED)
BEFORE INSTALLING YOUR LINER, YOU MUST FIRST REMOVE THE SPARE TIRE, SPARE TIRE MOUNTING
BRACKETS AND THE JACK TOOL STORAGE POUCH. YOU CAN THEN INSTALL YOUR LINER. THE
ATTACHING STUD FOR THE JACK TOOL POUCH WILL PASS THROUGH THE HOLE PUNCHED IN YOUR
LINER. RE-INSTALL THE JACK TOOL STORAGE POUCH, PLACING IT INSIDE THE LINER AND USING THE
FACTORY MOUNTING HARDWARE.
TO INSTALL THE OPTIONAL THIRD ROW SEAT IN YOUR HUMMER, JUST TRIM AWAY THE MATERIAL
INSIDE OF THE FOUR BANDED AREAS (SHOWN ABOVE HATCHED). YOU CAN TRIM JUST THE LONG SIDES
AND ONE END, TUCKING THE REMAINING FLAP UNDER THE SECURING BAR (SEE PHOTOS ON BACK).
MAKE CERTAIN THAT THE SEAT IS SECURELY FASTENED BEFORE OPERATING YOUR VEHICLE.
2130.doc
09/10/02
Loading...