Husky Liners 2110 User Manual

THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely unroll and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your vehicle with a weight in each corner (a book works well). After about 15 minutes, your liner will remain flat. In colder climates this “relaxing” may take longer; moving the liner inside will speed up the process. Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable.
The easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR
CHEVROLET/GMC SUBURBAN CARGO LINER
TO INSTALL YOUR THIRD SEAT WITH THE LINER IN PLACE, TRIM AWAY THE MATERIAL INSIDE OF THE RAISED BANDS (SHOWN DARKENED). A UTILITY KNIFE WORKS WELL.YOU MAY REMOVE THE FACTORY TRIM BEZELS FROM THE CARPET AND RE-INSTALL OVER YOUR HUSKY LINER. THE BEZELS WILL COVER THE RAISED BANDS.
TO ACCESS YOUR FACTORY CARGO TIE-DOWN HOOKS WITH YOUR LINER IN PLACE, SLIT THE FOUR SMALLER RAISED AREAS SHOWN CIRCLED AND PULL THE HOOKS UP THROUGH THE LINER.
2110.DOC Rev: 0
01/26/01
Loading...