Husky Liners 2108, 3108 User Manual

2108.doc
Rev: 0

08/12/04

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely

unroll and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your vehicle

with a weight in each corner (a book works well). After about 15 minutes, your liner will remain flat. In colder

climates this “relaxing” may take longer; moving the liner inside will speed up the process.

Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable. The

easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well.

Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.

INSTALLATION INSTRUCTIONS FOR YOUR CHEVY EQUINOX

CARGO LINER

IF YOUR CHEVY EQUINOX COMES EQUIPPED WITH THE FACTORY SUBWOOFER MOUNTED
IN THE LOWER RIGHT HAND SIDE OF THE CARGO AREA. YOUR CARGO LINER CAN EASILY
BE TRIMMED TO ACCOMMODATE THIS FEATURE. TO TRIM, CUT ALONG THE OUTER EDGE
OF THE MOLDED STEP AND ALONG THE EDGE OF THE TREAD ON THE RAISED PORTION OF
THE LINER. THIS WILL LEAVE A _” LIP ALONG THE TRIMMED EDGE (SEE ABOVE).

TO ACCESS THE FACTORY CARGO TIE-DOWN
HOOKS WITH YOUR LINER IN PLACE, MAKE
A HORIZONTAL SLIT ACROSS THE CENTER
OF THE TWO (2) RAISED AREAS SHOWN HERE
CIRCLED. THEN PUSH/PULL THE HOOKS UP
THROUGH THE LINER.

TO ACCESS THE SIDE WALL FACTORY
CARGO TIE DOWN HOOKS TRIM AWAY
THE MATERIAL SHOWN IN THE
HATCHED AREAS. A TRIMMING QUIDE IS
MOLDED INTO THE LINER.