HUSH Mamia Comfort User Manual

Comfort Baby Monitor

User Manual

English

AFTER SALES SUPPORT

PRODUCT CODE: 63151 01/15

0845 340 3880
1890 944 542

www.myhush.co.uk

MK3202 Aldi Baby Monitor Instr booklet.indd 2 22/09/2014 12:02

2 Hush, Agecroft Road, Pendlebury, Manchester M27 8SB

Baby Monitor

Thank you for purchasing this baby monitor. Please read the
instructions and warnings carefully before use to ensure the safe and
satisfactory operation of this product.

Contents

Important safety information 3

Your baby monitor 4

Instructions for use 5

Check the package contents 5

Setting up the parent unit 5

Setting up the baby unit 6

Volume 6

Battery low 6

Baby alert 6

Parent to parent paging 7

Night-light 7

Low power 7

Simple solutions 8

Helpdesk 8

General information 9

Changing the batteries 9

Guarantee 10

WEEE Directive 10

IREGB

Contents

MK3202 Aldi Baby Monitor Instr booklet.indd 3 22/09/2014 12:02

Important safety information

Your baby monitor should be treated with care. The information below has
been provided in the interest of safety and will help you to enjoy this product

and the benets it brings for many years.

Use of this equipment is no substitute for personal attention and
supervision of a child.

Keep the product and all
its parts out of reach of
small children.

Batteries are small objects.
Replacement of the batteries
must be done by adults.

Keep it dry. Avoid exposure
to precipitation, humidity and
liquids which could all affect the
product circuitry.

DO NOT leave it in high
temperatures as electronic
devices and plastic parts may
warp in heat.

DO NOT leave it in low
temperatures as moisture can
form inside the product, which
may damage the circuit board.

DO NOT use harsh chemicals,
cleaning solvents or detergents
to clean the product. Wipe with
a damp (not wet) soft cloth
to clean.

DO NOT attempt to open
the product. Unauthorised
handling of the device may
damage it and will void your
warranty.

Only use the power supply
that came with the product.
Using an unauthorised power
supply will invalidate your
guarantee and may product.

Radio signals transmitted
between the parent and baby
units may cause interference
to hearing aids.

DO NOT use your baby
monitor near emergency/
intensive care medical
equipment, if you have a

pacemaker tted or during an

electrical storm.

Helpline: UK - 0845 340 3880 IRE - 1890 944 542 Email: [e-mail] 3

Important Safety Information

IREGB

MK3202 Aldi Baby Monitor Instr booklet.indd 6 22/09/2014 12:02

Your baby monitor

Noise indication light

Speaker

Volume down

Power on/off

Press and release to power on

Press and hold to power off

Power on/off

Press and release to power on

Press and hold to power off

Microphone

Page

Press and hold for 2 seconds

to ‘Page’ the Parent unit

Night-light

Power on/off light

Flashes when the batteries

are charging

Link light

Volume up

4 Hush, Agecroft Road, Pendlebury, Manchester M27 8SB

Your baby monitor

IREGB

MK3202 Aldi Baby Monitor Instr booklet.indd 7 22/09/2014 12:02

Instructions for use

Check the package
contents

The package contains:

1 parent unit (receiver) with
belt clip

1 charger pod with xed

mains adaptor
2 x NiMH rechargeable
batteries
1 baby unit (sender)
1 mains adaptor
1 instruction manual

Setting Up
At the parent unit

1. Remove the belt clip by pulling

downwards.

2. Remove the battery cover on the
back of the parent unit.

3. Insert the 2 x AAA Nickel Metal
Hybride rechargeable batteries
provided, taking care to note the
‘+’ and ‘-’ markings and position
the batteries the correct way
round. Replace the battery
cover.

4. Replace the belt-clip by sliding
into place until it clicks home.

5. Plug the charger pod mains
power socket and switch on.

6. Place the parent unit in the
charger pod and charge for a
minimum of 13 hours before

rst use or if it has not been

used for a long time.

The red power light on the

parent unit will ash when the

batteries are charging.

Note: The parent unit cannot
be used without rechargeable
batteries, even if it is placed in
the charger.

7. Press and release the ‘Power’
button on the front of the parent
unit to switch it on.

Setting Up
At the baby unit

1. Connect the power lead to the

bottom of the baby unit and plug
the mains adaptor into a mains
power socket and switch on

2. Press and release the ‘Power’
button to switch on

Note: The baby unit should be
placed about 1m to 1.5m away
from the baby’s cot or playpen

on a at and stable surface.

Never place the baby unit inside
the cot, bed or playpen. Make
sure the unit, cords and mains
adaptor are out of reach of the
baby and other young children.

Helpline: UK - 0845 340 3880 IRE - 1890 944 542 Email: [e-mail] 5

Instructions for use

IREGB

MK3202 Aldi Baby Monitor Instr booklet.indd 10 22/09/2014 12:02

Never place either the parent or baby
unit on antique or polished surfaces.

When you have set up your baby
monitor, you will be able to hear the
sounds in your baby’s room through
the speaker on the parent unit. The
green noise indication light will also

ash with the sound volume level.

Note: If the connection between the
parent and baby unit is broken at any
time, the ‘Link’ light on the parent unit

will ash, the parent unit will beep

and the green noise indication light
will no longer react to any sounds.To
re-establish the link, please refer to
page 8.

Volume

You can adjust the volume of the
sounds that you can hear through the
parent unit by using the up and down
buttons on the front of the parent unit.
This will not affect the sensitivity of
your baby monitor, only the volume of
the sounds that you can hear.

Battery charge indicator
and battery low warning

The parent unit can operate for a
maximum of 10 hours when it is out of
the charger pod but this depends on
the level of charge in the batteries.
If the battery level is low, the red
‘Power’ light on the parent unit will

begin to ash and you will hear a

warning ‘beep’.

You should return your parent unit
to the charger pod to re-charge the
batteries. You can still use your parent
unit whilst it is charging in the charger
pod. (Check that the red charging

light is ashing when your parent unit

is in the charger pod, lights up).

Baby Alert

If the volume on your parent unit is
turned down very low, you will hear
a warning beep if the noise levels in
your baby’s room activate the light on
the parent unit. This is a really useful
feature if you are just using the noise
indication lights to monitor the noise
levels in your baby’s room.

To stop the alert tone and turn off
the baby alert feature, just turn the
volume back up on the Parent unit.

6 Hush, Agecroft Road, Pendlebury, Manchester M27 8SB

Instructions for use

IREGB

MK3202 Aldi Baby Monitor Instr booklet.indd 11 22/09/2014 12:02

Parent to Parent Paging

This is a useful feature if one parent
is in the baby’s room and needs to
contact the other parent. You can

also use this feature to ‘nd’ a mislaid

parent unit.

At the baby unit

1. Press and hold the ‘Page’

button for 2 seconds and then
release. The parent unit will
emit a tone.

2. Press the ‘Page’ button again to
turn off the alert tone.

At the parent unit

When the page tone sounds you can
silence it by pressing and holding any
button on the
parent unit.

Night-light

The baby unit has a night-light which
has a soft glow, providing comfort and
reassurance for your baby.

Low Power

In normal use your baby unit will have
a constant low level communication
with the parent unit at all times.
With the Hush baby monitor you
can choose to reduce this level of
communication or power usage so
that the baby unit only communicates
with the parent unit when there are
sounds in your baby’s room higher
than the set sensitivity level.

Note: It may take up to 8 seconds
for the baby unit to transmit a signal
to the parent unit to establish digital
communication when low power mode
is switched on.

At the baby unit

1. To switch low power mode on,

slide the switch underneath the
baby unit to ‘On’.

Helpline: UK - 0845 340 3880 IRE - 1890 944 542 Email: [e-mail] 7

Instructions for use

IREGB

MK3202 Aldi Baby Monitor Instr booklet.indd 12 22/09/2014 12:02

Simple Solutions

If you are experiencing problems
with your baby monitor, there are
some quick and easy checks
you can.

The parent and baby units will not
power on.

• Please check that you have
correctly installed the
batteries in the parent unit
and that the mains power
for the baby unit and parent
unit charging pod is
connected and switched on.

The ‘Link’ light on the parent unit

is ashing, the noise indication

LEDs are not functioning and you
cannot hear sounds from your
baby’s room.

• You may have moved out
of range of the baby unit.
Move the parent unit closer
and wait 5 seconds for the
link to re-establish.

• You may need to manually
re-establish the link. Turn
both units off and then press
and release the ‘Power’ button
on the baby unit. Press and
hold the ‘Power’ button for 2
seconds on the parent unit.

• After a few seconds the green
‘Link’ light will come on.

You can’t hear your baby on
the parent unit and the ‘Link’
light is still glowing steadily.

• Check that the volume on the
parent unit is turned up.

The baby monitor is making
a high pitched ear-piercing
noise.

• This can happen if the baby and
parent unit are too close to each
other. Move the parent unit
further apart from the baby unit.
Clean the charging contacts
with a soft, dry cloth.

If you are experiencing any

difculty after making the

above checks, please call
the helpdesk for further
assistance.

Helpdesk

The helpdesk is open from: UK -
8am to 9pm, Monday to Saturday
(excluding bank holidays),
9am to 7pm Sundays. and can
be contacted on 0845 340 3880
(local call rate) IRELAND -
8am to 9pm, Monday to Saturday
(excluding bank holidays),
9am to 7pm Sundays. and can
be contacted on 1890 944 542
(local call rate) or email support@
myhush.co.uk.

8 Hush, Agecroft Road, Pendlebury, Manchester M27 8SB

Simple Solutions

IREGB

MK3202 Aldi Baby Monitor Instr booklet.indd 9 22/09/2014 12:02

• Only use recommended
batteries or those of an
equivalent type.

• Batteries are to be inserted
with the correct polarity.
Follow the diagram in the
battery compartment.

• DO NOT short circuit the supply
terminals.

• Promptly remove exhausted
batteries from the parent and
baby units and replace if the
operating times have become
reduced over time.

• Remove the batteries from the
parent and baby units if they will
not be used for an extended
period of time.

• DO NOT attempt to recharge
non-rechargeable batteries.

• Dispose of dead batteries
properly.

• DO NOT mix old and new
batteries or batteries of
different types (i.e., alkaline/
standard).

• DO NOT incinerate used
batteries.

• DO NOT dispose of batteries

in a re, as they may explode

or leak.

• DO NOT attempt to open the
battery outer casing.

• Batteries are harmful if
swallowed, so keep away from
young children.

General information

Changing the parent unit batteries

The parent unit is supplied with 2 x AAA Nickel Metal Hydride Rechargeable
Batteries. To change the batteries please refer to page 5 of this guide.

Helpline: UK - 0845 340 3880 IRE - 1890 944 542 Email: [e-mail] 9

General Information

IREGB

MK3202 Aldi Baby Monitor Instr booklet.indd 8 22/09/2014 12:02

What Your 3 Year
Warranty Means

Great care has gone into the
manufacture of this product and it
should therefore provide you with
years of good service when used
properly. In the event of product
failure within its intended use over

the course of the rst 3 years after

date of purchase, we will remedy
the problem as quickly as possible
once it has been brought to our
attention. In the unlikely event
of such an occurrence, or if you
require any information about the
product, please contact us via our
helpline support services, details of
which are to be found both in this
manual and on the product itself.

WEEE Directive

WEEE Directive – Directive 2002/96/
EC of the European Parliament
and Council of 27th January 2003
on waste electrical and electronic
equipment. At the end of the product’s
lifecycle, you should not throw this
product into the normal household
waste but take it to a collection point
for the recycling of electrical and
electronic equipment.

The ‘WEEE’ symbol below, on the
product, user manual and packaging
indicate this.

Please contact your local authority if
you need more information about the
collection points in your area.

For more information telephone
Envirowise on 0800 585794.

10 Hush, Agecroft Road, Pendlebury, Manchester M27 8SB

What Your 3 Year Warranty Means

IREGB

MK3202 Aldi Baby Monitor Instr booklet.indd 5 22/09/2014 12:02

Helpline: UK - 0845 340 3880 IRE - 1890 944 542 Email: [e-mail]

IREGB

MK3202 Aldi Baby Monitor Instr booklet.indd 4 22/09/2014 12:02

Helpline

UK: 0845 340 3880

IRE: 1890 944 542

(local call rate)

Sept 14/Issue 1

MK3202 Aldi Baby Monitor Instr booklet.indd 1 22/09/2014 12:02