Page 1
NOTE: THESE INSTRUCTIONS MUST NOT CONTRAVENE YOUR
LOCAL ELECTRICAL AUTHORITY REGULATIONS, WITH WHICH
ALL INSTRUCTIONS HERE IN MUST COMPLY.
PLEASE KEEP INSTRUCTIONS FOR FUTURE REFERENCE.
BLADE
100mm (4”) junction box compatible
Installation instructions
the Base Plate to the desired surface.
Fixing screws are provided however
make the input connections. All
connections should be water tight to
power cables.
See diagrams below
Warning: Do not connect secondary side (output) of a live
driver to the Fixture. This will cause a spike in voltage that
can damage the LED. When connecting or disconnecting
the tting always ensure the 120/240V power supply is
disconnected.
When using a photocell and/or timer we recommend using
devices with relay outputs as opposed to electronic. The
high frequency of electronic devices can lead to failure of
the LED driver.
Make input connections according to diagram below.
INPUT: 100-277VAC
Make input connections according to diagram below.
24VDC CONSTANT
VOLTAGE
Make input connections according to diagram below.
120/240V (RETRO) CONNECTIONS
(white)
(Black)
(Purple)
(Grey)
24VDC INPUT CONNECTIONS
POSITIVE
(white)
(Black)
NEGATIVE
REMOTE DRIVEN (SERIES) CONNECTIONS
DRIVER OUTPUT:
CONSTANT
CURRENT 700mA
Max, 37Vdc
(white)
(Black)
POSITIVE
NEGATIVE
Page 2
NOTE: THESE INSTRUCTIONS MUST NOT CONTRAVENE YOUR
LOCAL ELECTRICAL AUTHORITY REGULATIONS, WITH WHICH
ALL INSTRUCTIONS HERE IN MUST COMPLY.
PLEASE KEEP INSTRUCTIONS FOR FUTURE REFERENCE.
Adjusting Head position.
Use Hex (allen) key provided to
loosen indicated screws to
adjust rotation and head angle.
Once desired postioning is
achieved tighten screws to lock
in place
LED circuit board
Optic baffle and optic holder
Lens
Flange
LED replacement
Undo 8 face plate screws. Remove face plate and lens. Remove
black optic baffle and unscrew optic holder. Pay close attention to
component order. The LED circuit board can now be changed.
Reverse action to seal making sure components are replaced in
correct order. Incorrect order can lead to failure of LED and/or
leaking. Please ensure no dirt or grit is present around lens or
gasket.
Loading...