Hunter Stoves Double Herald 14 CE, DOUBLE HERALD 6 CE, Herald 14 Double-Double CE Installation And Operating Instructions Manual

D O U B L E /

D O U B L E / D O U B L E

D O U B L E /D O U B L E /

H

H E R A L D

HH

E R A L D 1 4

E R A L D E R A L D

D O U B L E

D O U B L ED O U B L E

1 4

1 41 4

C E

C E

C EC E

M U L T I F U E L

M U L T I F U E L

M U L T I F U E L M U L T I F U E L

C L E A N B U R N

C L E A N B U R N

C L E A N B U R N C L E A N B U R N

S T O V E

S T O V E

S T O V ES T O V E

Installation and Operating Instructions

An accredited competent person must carry out the installation of this appliance;
alternatively, your local Building Control Officer can approve the completed
installation, should a non-accredited engineer undertake the installation. It is an
offence, under UK law, not to comply with this advice. Please hand these
instructions to the stove user when the installation is complete. Leave the system
ready for operation and instruct the user in the correct use of the appliance and
operation of controls.

Herald 14 Double-Double CE

Technical Specification

Wood

Total Efficiency 71.1 %

Nominal Heat Output 17.8 KW

Mean CO Emission (at 13% O2) 0.35 %
Mean Flue Gas Temperature 443 °C

Flue Gas Mass Flow 12.5 g/s

This appliance is not suitable for use in a shared flue

This appliance is suitable for intermittent burning

Assembly Instructions

PLEASE READ THESE INSTRUCTIONS CAREFULLY

It is important that your stove is correctly installed, as Hunter Stoves Limited cannot

accept responsibility for any fault arising through incorrect use or installation.

Important Warning

This stove must not be installed into a chimney that serves any other heating appliance.

There must not be an extractor fan fitted in the same room as the stove as this can cause the stove to

emit fumes into the room.

Flue Collar

Place the Flue Gasket on the Top Plate Flue Exit. Place the Flue Collar on top of the Gasket. Secure to
the four locating tabs, inside the flue outlet, using the M6 nuts & bolts supplied. Fit the 2 - M8 carriage
bolts, washers & nuts into the Damper Holes, located on each side of the Flue Collar.

Fire Bricks

The Fire Bricks, in this appliance, are factory fitted. The following set of photos show the removal sequence
that you will need to employ when servicing your Hunter Stove.

Side Bricks

Remove the outer 3 Riddling Bars (each side),

Slide out the Side Bricks from base, into the

Stove.

Baffle

Lift the Baffle and slide to the left.

When the right side of the Baffle clears

the Baffle Support, lower it into the Fire

Box and remove.

HETAS Ltd (Heating Equipment Testing and

Installation Instructions

These instructions cover the basic principles to ensure satisfactory installation of the stove,
although detail may need slight modification to suit particular local site conditions. In all cases
the installation must comply with current Building Regulations, Local Authority Byelaws and
other specifications or regulations as they affect the installation of the stove. It should be noted
that the Building Regulations requirements may be met by adopting the relevant
recommendations given in British Standards BS 8303, BS 6461 and BS 7566 as an alternative
means to achieve an equivalent level of performance to that obtained following the guidance given
in Approved Document J.

Competent Persons Scheme

Members of the following schemes may self-certify the installation of this stove. If the installer is not a
member of one of these schemes, your local building control department must approve the installation.

Scheme

APHC (Association of Plumbing and Heating
Contractors (Certification) Limited

Building Engineering Services Competence
Accreditation (BESCA Limited)

Web address

www.aphc.co.uk

www.hvca.org.uk /
www.besca.org.uk

Telephone

02476 470 626

0800 652 5533

Approval Scheme)

www.hetas.co.uk

NAPIT Registration Ltd www.napit.org.uk

NICEIC Group Ltd www.niceic.org.uk

01462 634721

0870 444 1392

0800 013 0900

Health and Safety Precautions

Handling

Adequate facilities must be available for loading, unloading and site handling.

Fire Cement

Some types of fire cement are caustic and should not be allowed to come into contact with the skin. In
case of contact, wash immediately with plenty of water.

Asbestos

This stove contains no asbestos. If there is a possibility of disturbing any asbestos in the course of
installation then please seek specialist guidance and use appropriate protective equipment.

Metal Parts

When installing or servicing this stove, care should be taken to avoid the possibility of personal injury.