Hunter Fan ME003-01 User Manual

Piccolo

Owner’s Manual

• Assembly

Electrical Rating:

Weight ±2 lbs:

• Installation

Product:

Trademark:

Quantity:

Ceiling Fan
Revolutions
1 Piece
120V ~ 60Hz
10 lbs (4.5 kg)

• Operation

ME003-01 r090414

Congratulations!

You have chosen the best. Your new Revolutions ceiling fan will provide you
with many years of comfort and satisfaction.

Read and Save These Instructions

This product conforms to UL Standard 507.

WARNINGS

w.1 - To reduce the risk of personal injury, attach the fan directly to the support
structure of the building according to these instructions, and use only the hardware
supplied.

w.2 - To avoid possible electrical shock, before installing or servicing your fan,
disconnect the power by turning off the circuit breakers to the outlet box and
associated wall switch location. If you cannot lock the circuit breakers in the off
position, securely fasten a prominent warning device, such as a tag, to the service
panel.

w.3 - To reduce the risk of fire, electrical shock, or motor damage, use only Hunter
Speed Controls.

w.4 - To reduce the risk of personal injury, do not bend the blade brackets when installing
the blade brackets, balancing the blades, or cleaning the fan. Do not insert foreign
objects in between rotating fan blades.

CAUTIONS

c.1 - All wiring must be in accordance with national and local electrical codes ANSI/
NFPA 70. If you are unfamiliar with wiring, use a qualified electrician.

c.2 - Use only Hunter replacement parts.

ME003-01 09/04/2014

2

Unpacking the Fan

1. Unpack your fan and check the contents. Do not discard the box. If warranty replacement or repair
is ever necessary, the fan should be returned in its original packaging. Remove all parts and hard­ware. Do not lay the motor housing on its side; the decorative casing may shift.

2. Examine all parts. You should have the following:

1. Mounting Bracket

2. Motor

3. Motor Housing

4. Blade Irons

5. Blades

6. Parts Pack Containing:
a. Mounting bracket hardware (extra screw

and washer, wire nuts, extra motor screw,
and washer)

b. Noise isolators, blade nuts, blade screws

1

2

4

5

Note: Some Revolutions fan models will have slightly different parts than shown here,
depending upon the model. Basic installation procedures are similar for all fan models.

Tools and Materials Required

• Phillips screw driver

• Flat Head screw driver

• Adjustable pliers or wrench

• Step Ladder

• Wire Cutter

• Electrical tape

Assessing the Installation Location

3

6

,8 Meters

from blade tip
to nearest wall
or obstruction

2,1 Meters

from bottom

edge of blade to

the oor

CAUTION

To reduce the risk of injury to
persons, install fan so that the blade
is at least 2,1 m above the floor.

ME003-01 09/04/2014

3