Hunter Fan 20080902, 43052-01 User Manual

English

Evaporative HumidifierEvaporative HumidifierEvaporative Humidifier

English

Owner’s Guide

Models

32200 38200

WARNING / CAUTION

Important Safety Instructions:

Read all instructions before using this

humidifier.

Thank you for purchasing the Care Free® Ultra Evaporative Humidifier by Hunter Fan Company. Please read and save these instructions to receive maximum benefit and performance from your humidifier.

TABLE OF CONTENTS

1. This humidifier may not work properly on an uneven surface. ALWAYS place this humidifier on a firm, level and water resistant surface. ALWAYS place the humidifier at least six (6) inches away from walls and heat sources such as stoves, radiators or heaters.

2. ALWAYS place the humidifier in an area that is out of the reach of children.

3. Before using the humidifier, extend the cord and inspect for any sign of damage. DO NOT use the product if the cord has been damaged.

4. This product has a polarized plug as a safety feature (one blade is wider than the other). This plug will fit into a polarized outlet only one way. If the plug does not fully fit into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to defeat or override this feature.

5. ALWAYS unplug and empty the humidifier when it is not in operation or while it is being cleaned.

6. DO NOT tilt or move the humidifier while it is in operation. Never move the humidifier while there is water in the tank. Empty the water tank, turn the unit off, and unplug the unit before moving.

7. In addition to routine maintenance which may be required, this humidifier requires seasonal cleaning. Refer to and follow the instructions for

CLEANING THE HUMIDIFIER AND THE WATER TANK.

8. This unit was designed to be used with distilled and/or tap water. DO NOT add scented oils, perfumes or fragrance additives to the water.

READ AND SAVE THESE NSTRUCTIONS

Warning / Caution .................................. 3

Read and Save These nstructions ........ 3

How the Care Free® Evaporative

Humidifier Works ................................... 4

Humidifier Parts ..................................... 4

Using Your Humidifier ............................ 4

Refilling The Water Tank ........................ 5

Cleaning The Humidifier

and Water Tank...................................... 6

Replacing The Humdifier Wick .............. 6

Service Parts ......................................... 7

Technical Support .................................. 7

Other Hunter Products........................... 7

Español.................................................. 9

Français ............................................... 17

The Care Free® Humidifier Evaporative Humidifier has a unique patented design with several innovative features:

• Low Maintenance – Other humidifiers

have paper filters that need to be replaced every few months. Our exclusive PermaWick™ filter saves time and money. It’s designed to last season after season, saving up to $45 a year. No wet paper odors either.

• Regulated Release™ System – By

dispersing water from the top of the PermaWick™ filter, stagnant water around the PermaWick™ filter is eliminated, and the buildup of mineral residue that can clog the filter and impede performance is eliminated. NOTE: The filter has a coating on the wick which may make it appear old or used, but is actually new.

• Built-in Antimicrobial Properties –

The plastic parts and the PermaWick™ filter have built-in antimicrobial properties to inhibit the growth of bacteria, mold and fungi that may affect these parts.

NOTE: This product contains antimicrobial properties which are built-in to inhibit the growth of bacteria which may affect the plastic and PermaWick™ filter in the humidifier. These properties do not extend to the water, humidified air or users. Conduct routine cleaning and maintenance based upon use and individual conditions.

• No White Dust – The Care Free®

Humidifier Evaporative Humidifier produces no white dust that can settle on furniture or be inhaled.

How the Care Free®

Evaporative Humidifier Works

HUMIDIFIER PARTS

Figure 1.

USING YOUR HUMIDIFIER

1. Remove the Hunter® Evaporative Humidifier from its packaging.

2. Place the humidifier on a hard, flat, water resistant surface. Always place the humidifier at least six (6) inches away from walls and sources of heat.

3. Make sure the Power/Speed Control

is in the ‘OFF’ position. NOTE: The Power/Speed Control should always be off before unplugging the humidifier, moving the humidifier, or refilling the water tank. See Figure 2.

Figure 2.

Figure 5.

Figure 3.

5. Grasp the Water Tank by its Tank Tote and remove it from the Base.

6. Turn the Water Tank upside-down and remove the Tank Fill Cap. See Figure

Figure 4.

7. Fill the Water Tank with water, return the Tank Fill Cap to its position and tighten it, and return the Water tank to the Base.

8. Plug the humidifier’s Power Cord into a standard household power outlet.

9. Turn the Power/Speed Control to your desired humidifier fan speed. See Figure 5.

REFILLING THE WATER TANK

1. When the water tank level is low, turn the humidifier ‘OFF’, and unplug.

2. Remove the tank and take it to the sink or tub to refill.

3. Turn the tank upside down and unscrew the tank cap by turning it counterclockwise. Empty the tank, refill with fresh cool water (never use hot water), and replace the tank cap. Be sure not to overfill the tank as water damage may occur to furniture or flooring due to spillage. HUNTER WILL NOT ACCEPT RESPONSIBILITY

FOR DADAMAGE TO PROPERTY

CAUAUSED BY WATER SPILLAGE.

4. Carry the tank back to the humidifier. Turn the tank upright and place it on the humidifier. Be sure that the tank is seated properly in the base. If the tank is properly located on the base, you will see air bubbles flowing up into the tank.

4. Lift the Main Housing to ensure the

Wick is properly seated, resting on the bottom of the base and not tilted or otherwise out of position. See Figure

3. Place the Main Housing back on the

Base.

REPLACING THE HUMDIFIER WICK

NOTE: The humidifier’s Wick is made of paper and is NOT washable.

Over time, minerals in your water will build up in the humidifier’s Wick, degrading its ability to absorb water and reducing the humidifier’s output. Therefore, you should replace the humidifier’s Wick every 4 - 8 weeks, depending on the hardness of your water.

1. Turn the humidifier ‘off’ and unplug the unit.

2. Lift the Main Housing, remove it from

the Base, and set it aside.

CLEANING THE HUMIDIFIER AND

WATER TANK

Many regions have hard water with

high concentrations of minerals. When water evaporates from The Hunter® Evaporative Humidifier, minerals may be left behind. These minerals can form a hard white scale which can be removed by following the cleaning instructions. The frequency of cleaning due to mineral build up can vary depending upon the quality of water you may have. Refer to Figure 1 for part names.

1. Turn the humidifier ‘off’ and unplug the unit.

2. Lift the main housing and remove the water dispersion tray and the wick. The motor is attached to the main housing. Do not place the motor near water. Do not use a wet towel on the motor or motor housing as electrical shock may occur.

3. Replace the humidifier’s wick every 4 8 weeks or when it has turned brown.

4. Remove the water tank from the base and empty any water that is left in the tank. Soak the base in a mixture of one (1) gallon of water and eight (8) ounces of vinegar for 20 minutes. The base is dishwasher safe.

5. After soaking, wipe the base with a soft cloth or sponge to remove any mineral build up. Rinse with clean water several times. If you are planning on storing the humidifier, be sure the base is completely dry.

6. Fill the water tank with one (1) gallon of water and eight ounces of undiluted white vinegar. Replace the tank cap and shake the tank vigorously until all interior surfaces of the tank have been exposed to the water/vinegar mixture.

7. Empty the tank of the water/vinegar mixture. Rinse it several times with clean water and then replace the tank cap. If you are planning on storing the humidifier, dry it inside and out, leaving the cap off to allow the tank to completely dry. Continue to clean the other parts of your humidifier.

8. Wipe the surfaces of the main housing

with a soft cloth.

9. Once all the parts are clean, reassemble the humidifier, and follow

the USING YOUR HUMIDIFIER to

continue use. If you are storing the humidifier, make sure the parts are completely dry, reassemble, and store in a dry location.

OTHER HUNTER PRODUCTS

To learn more about Hunter Fan

Company products, please see our web

page at:

www.hunterfan.com

3. Grasp the humidifier Wick, hold it over the base, and squeeze the water from it. This will keep water from dripping onto your floor. You may also want to wrap the Wick in a towel to keep it from dripping while you transport it to disposal.

4. Replace the old Wick with a new Hunter humidifier Wick, number 31911. New Wicks are available at your local Hunter retailer or at www.hunterfan. com.

5. Ensure the Wick is properly seated, resting on the bottom of the base and not tilted or otherwise out of position.

6. Return the Main Housing to its position on the Base. Make certain the Main

Housing is properly seated on the Base.

7. Plug the humidifier’s Power Cord into a standard household power outlet and turn the Power/Speed Control to your desired setting.

SERVICE PARTS

Model No. ...................................... 32200

Base .............................................. 97676

Water Tank..................................... 97678

Tank Cap ....................................... 87843

Filter ................................................31911

Hunter Original® Fans

Programmable

Thermostats

Air Purifiers

To obtain a service part for your humidifier, call customer service at 1-888-830-1326 or e-mail us at techsupport@hunterfan.com. Please be prepared to tell the operator the model number of your humidifier and the name of the part you need to replace and the part number. Refer to Figure 1 for part names.

Fan Company

2500 Frisco Avenue

Memphis, Tennessee 38114

Printed in china and Taiwan

Fan Company

2500 Frisco Avenue

Memphis, Tennessee 38114

+ 17 hidden pages

Hunter Fan 20080902, 43052-01 User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual