Read this manual thoroughly. The following notes should help you with getting
around your thermostat:
• The thermostat temperature can be set in increments of 1°F (1°C).
• After 15 minutes without a key press, the thermostat will return to the home
display screen and save any changes you have made.
If you need any assistance with installion or setup of your new
Hunter Thermostat, please call us, our technical support staff is
ready to help!
USA: 1-888-830-1326
Canada: 1-866-268-1936
Hours of operation are from 7:00 am to 7:00 pm Monday - Friday and 8:00 am
to 5:00 pm on Saturday, Central Time. You may also contact us over the Internet
at:
2. HE/HG Switch - allows you to set your furnace to Gas/Oil or Electric, based
on the type of system you have.
3. Allows your thermostat to operate your HVAC system* properly by indicating
the system type that you have.
3
*Conventional System: Uses a condensing unit for cooling and a
separate furnace system for heating.
*Heat Pump System: Uses the condensing unit for both heating and
cooling.
NOTE: If you are unsure of your system type it may be necessary to
contact our technical support department at 1-888-830-1326, your
HVAC manufacturer, or a local HVAC technician to determine this.
Improper selection of your system type could cause the thermostat to not
operate your system properly.
This chapter will outline the various alerts the thermostat will report to you
and how to respond to them.
1. Low Battery: This icon will appear when your batteries are
starting to run low on power and should be changed to avoid system
interruptions, (Figure 1) Change the batteries by gripping the sides
of the thermostat rmly and pulling straight back, (Figure 1a). The
batteries are located on the backside of the thermostat. The thermostat
requires 2 (AA) batteries to operate. If you do not replace the batteries
in a timely manner, the screen will go blank except for the low battery
warning, (Figure 1b). Your system will shut down and will not operate
until you replace the batteries. Replacing the batteries will clear this
alert.
Note: Settings will not be lost while replacing the batteries. They are
stored in the thermostat’s memory.
2. Filter Change: When this icon appears on the screen, it indicates
you should check your furnace lter to see if it needs to be replaced.
To reset this counter see page 16.
3. Auxiliary Heat: On multi-stage heat pumps this alert indicates
your second stage heat is running.
4. Check System: Some heat pump systems are equipped with the
ability to check system performance, indicated by the presence of
an “L” wire attached to the backplate. This icon will ash on screen
to alert the user that the heat pump is reporting a problem with
the system. It may be necessary to have the heat pump checked or
serviced by an HVAC technician.
Under your menu options you have the ability to reset your lter counter,
span settings, and temperature measurement. After making changes
to each menu option, the thermostat will show “Updated”, save your
changes, and move you back to the home screen.
To access these options:
1. Press the button.
2. Once in the menu options list, use the or buttons to scroll through
the menu items. The button will take you into the selected menu
item. To escape menu options, select a menu item by pressing ,
then press again.
3. RESET FILTER: If the lter indicator is ashing on the home screen you
can reset it here. Use the or buttons to select “Filter” and press
. The screen will ash “Updated” and return to the home screen.
4. SPAN 1: The next menu option is to set your thermostats primary
span. Use the or buttons to adjust between 1, 2, or, 3 degrees.
Press , the screen will ash “Updated” and return to the home
screen. The span setting regulates when and how long your system
will run. The span has been set at the factory to 2 which will allow the
system to turn on1OF (.05OC) above or below the set temperature and
run for 1OF (.05OC) above or below the set temperature.
Example: If your thermostat is set to turn on at 72O in heat mode, with
a span setting of 2, your thermostat will activate your furnace at 71Oand
shut it down when it reaches 73O. For cooling at 72O with a span of
2, your air conditioner will activate at 73O and shut down at 71O. This
setting can be changed to 1, 2, or 3. 1 will shorten your running time
while 3 will lengthen it.
5. SPAN 2: Unless you have a multi-stage conventional or heat pump
system, there is no need to change the second stage span. If you do,
use the or buttons to adjust between 1, 2, or, 3 degrees. Press
once this has been changed or if you need to make no changes.
Second stage span acts the same as your primary, but it determines
when and how long your second stage heat runs.
6. TEMP F/C: The thermostat can change your temperature reading
between Fahrenheit and Celcius. Use the or buttons to switch
between Fahrenheit (F) and Celsius (C) Press , the screen will ash
“Updated” and return to the home screen.
In the event that power is lost, the batteries will act as backup, saving
your settings and programs.
System Protection
To protect your system from cycling, system turning on and off rapidly,
your thermostat will prevent your system from turning back on for up to 3
minutes after it has been shut down.
Reset
In situations where your thermostat may not seem to be operating
properly or if you just want to reset and start over, press and hold the
and buttons for 5 seconds until the screen ashes “Updated!”. This will
restore the thermostat to factory condition.
20
44047-01 • 04/13/2010
7
ermostat Assistance
Troubleshooting and Support
Problem:
No display.
Solution:
1. Check battery position and battery life.
Problem:
Auto / Fan does not turn on.
Solution:
1. Move HG/HE switch to opposite position.
2. Check the fan setting and make sure that it is not set to off.
1. Check the system is in the right mode (heat or cool).
2. Be sure to wait up to 4 minutes for system protection if your system
was just on.
3. Check breakers to make sure power is getting to your system
4. Replace the batteries.
Problem:
Backlight does not come on.
Solution:
1. Replace the batteries.
22
44047-01 • 04/13/2010
7
ermostat Assistance
Troubleshooting and Support
Technical Support
If you need any assistance with installation or setup of your new Hunter
thermostat, please call us. Our technical support staff is ready to help!
USA: 1-888-830-1326
Canada: 1-866-268-1936
Hours of operation are from 7:00 am to 7:00 pm Monday - Friday and
8:00 am to 5:00 pm on Saturday, Central Time. You may also contact us
over the Internet at www.hunterfan.com.
The Hunter Fan Company warrants your Hunter Thermostat to be free
from defects in material or workmanship for a period of one year from
the date of sale to the original user or consumer purchaser. If your Hunter
Thermostat malfunctions or fails within the warranty period because of a
defect in material or workmanship, we will replace it.
THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES.
THE DURATION OF ANY IMPLIED WARRANTY, INCLUDING, BUT NOT
LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE, IN RESPECT TO YOUR HUNTER
THERMOSTAT IS LIMITED TO THE PERIOD OF THE EXPRESS WARRANTY
SET FORTH ABOVE.
This warranty is voided if your Hunter Thermostat is not purchased and
used in the USA. This warranty excludes and does not cover defects,
malfunctions or failures or your Hunter Thermostat which were caused
by repairs by persons not authorized by us, mishandling, improper
installation, modications or damage to the Hunter Thermostat while
in your possession, or unreasonable use, including failure to provide
reasonable and necessary maintenance.
24
44047-01 • 04/13/2010
8
1 Year Guarantee
Warranty
This warranty neither applies to batteries nor to deterioration of, nor
damage to the product caused by the use of faulty batteries. Return your
product, along with proof of purchase to Hunter Fan Company Service
Department, 7130 Goodlett Farms Pkwy Suite 400, Memphis, TN 38016.
You will be responsible for all insurance and freight or other transportation
charges to our factory. We will return your Hunter Thermostat freight
prepaid. Your Hunter Thermostat should be properly packed to avoid
damage in transit since we will not be responsible for any such damage.
Proof of purchase is required when requesting warranty service.
IN NO EVENT SHALL HUNTER FAN COMPANY BE LIABLE FOR
CONSEQUENTIAL OR INCIDENTAL DAMAGES.
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN
IMPLIED WARRANTY LASTS OR THE EXCLUSION OR LIMITATION
OF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE
LIMITATION MAY NOT APPLY TO YOU.
THE WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY
ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.