Hunter Fan 36205, 36207, 35207, 35205 User Manual

www.hunterfan.com

The Care Free®

Warm Mist Humidiﬁer

Models 35205, 35207, 36205, 36207

ENGLISH

See page 1

ESPAÑOL

Vea la página 15

READ AND SAVE THESE INSTRUCTIONS

Thank you for purchasing the Care Free

Warm Mist Humidiﬁer by Hunter Fan Company. Please read and save these instructions to receive maximum beneﬁt and performance from your humidiﬁer.

Important Safety Instructions:

Read all instructions before using

this humidiﬁer.

CAUTION: To avoid electrical

shock and/or ﬁre, please read all instructions before use.

1. This humidiﬁer may not work properly

on an uneven surface. ALWAYS place this humidiﬁer on a ﬁrm, level, and water resistant surface. ALWAYS place the humidiﬁer at least six (6) inches away from walls and heat sources, such as stoves, radiators, or heaters.

2. ALWAYS

place the humidiﬁer in an area

that is out of the reach of children.

3. Before using the humidiﬁer, extend the cord and inspect for any sign of damage. DO NOT use the product if the cord has been damaged.

4. This product has a polarized plug as a safety feature (one blade is wider than the other). This plug will ﬁt into a polarized outlet only one way. If the plug does not fully ﬁt into the outlet, reverse the plug. If it still does not ﬁt, contact a qualiﬁed electrician. DO

NOT

attempt to defeat or override this

feature.

5. ALWAYS

unplug and empty the humidiﬁer when it is not in operation or while it is being cleaned.

6. DO NOT

tilt or move the humidiﬁer while it is in operation. Never move the humidiﬁer while there is water in the tank. Empty the water tank, turn the unit off, and unplug the unit before moving.

7. In addition to routine maintenance which may be required, this humidiﬁer requires seasonal cleaning. Refer to and follow the instructions for CLEANING THE HUMIDIFIER AND THE WATER TANK.

8. This unit was designed to be used with

distilled and/or tap water. DO NOT add scented oils, perfumes or fragrance additives to the water.

9. DO NOT

attempt to move or disassemble the Base while there is hot water still in the unit. Allow a minimum of ﬁfteen (15) minutes cooling time before moving or disassembling the Base.

10. ALWAYS

use clean, cool tap water to ﬁll

the Water Tank.

11. To avoid the risk of electrical shock, DO

NOT

use an extension cord.

12. DO NOT

operate outdoors. This humidiﬁer is for indoor use only.

13. DO NOT

let water get into the air inlets on the back of the enclosure, the cord, or the plug.

14. DO NOT

store or use gasoline or other ﬂammable vapors and liquids near the humidiﬁer.

15. DO NOT

touch hot surfaces. DO NOT place hands or face directly over the Exhaust Grille while the unit is in operation.

16. DO NOT

allow the Exhaust Grille to directly face a wall surface. Direct mist aimed at a wall could cause damage, particularly to wallpaper.

Assembly Of Humidiﬁer Parts

The Care Free® Warm Mist Humidiﬁer has a unique, patented design with several innovative features:

• Removable Boiling Chamber

–

The detachable heater can be easily

removed for cleaning and maintenance.

• Humidiﬁcation System

– Water is passed through a heating element which creates warm mist to humidify the air. Stagnant water in the reservoir is eliminated due to minimal water quantity in the boiler reservoir.

• Built-In Antimicrobial Properties

–

The plastic parts in this humidiﬁer have

built-in antimicrobial properties to inhibit the growth of bacteria, mold and fungi that may affect these parts.

NOTE: The antimicrobial properties built-

into this humidiﬁer do not extend to the

How The Care Free® Warm Mist Humidiﬁer Works

water, humidiﬁed air or users. Conduct routine cleaning and maintenance based upon use and individual conditions.

• No White Dust

– The Care Free® Warm Mist Humidiﬁer produces no white dust that can settle on furniture or be inhaled.

NOTE: You may notice mineral deposits

accumulating in the tank base or on other components. This is normal and comes with regular usage conditions. If you would like to remove these deposits and maintain humidiﬁer performance, please see the section CLEANING THE HUMIDIFIER AND THE WATER TANK.

• Dishwasher Safe

– All components of The Care Free® Warm Mist Humidiﬁer are top-rack dishwasher safe, except for the powered base.

ENGLISH

1. Remove the Care Free® Warm Mist Humidiﬁer from its packaging.

2. Select a location for your humidiﬁer. The location should be ﬂat, hard, waterresistant, and at least six (6) inches away from walls and sources of heat. Mount the humidiﬁer on a drip tray if you are using the unit on a wood surface or other surface which could be damaged by accidental water spillage or condensation.

HUNTER WILL NOT ACCEPT RESPONSIBILITY FOR DAMAGE DUE TO WATER SPILLAGE.

3. Place the Base in the location you selected. Take the Water Tank to a sink or tub to ﬁll with water.

4. Unscrew the Tank Cap by twisting it counterclockwise and ﬁll the Water Tank with cool water.

NOTE: When the Water Tank is empty, the reﬁll indicator icon will turn ON and the unit will stop. You must press the RESET button after reﬁlling the Water Tank to reactivate the unit.

5. Replace the Tank Cap by screwing it clockwise onto the Water Tank.

6. Place the Water Tank back onto the Base. Make sure the Water Tank is properly seated on the Base or the humidiﬁer will not work properly.

HUNTER WILL NOT ACCEPT RESPONSIBILITY FOR DAMAGE DUE TO WATER SPILLAGE.

7. Make sure the Power Button is set to OFF and plug the humidiﬁer into the wall outlet.

CAUTION: Never plug in the humidiﬁer while your hands are wet, as electric shock could occur.

NOTE: Let the humidiﬁer sit for one minute after reﬁlling the tank, before turning the power back ON.

8. Push the Power Button to turn the humidiﬁer ON. Adjust the setting as needed.

Base

Water Tank

Operating Your Humidiﬁer

Functional Buttons

There are 6 buttons to control the functions of the humidiﬁer. You will hear a conﬁrmation ‘beep’ when a button is pressed.

1. POWER

– Press the POWER button

to setFF0009>0iHIiﬁe Tm[( (WER button )]TJETBT/T1_0 1 Tf9 0 0 1 101.9362 321 Pr)10(ess the PO)18again9>0iturn Tm[(WER button )]TJETBT/T1_0 1 Tf9 0 0 0 101.9362 32unit OFF(.)3iﬁerrm4.

LCD Messages

1. Misting Control:

When the humidity is higher than the set humidity, the heater will stop misting, and the misting icon will blink. When the unit is in normal misting mode, the misting icon will be illuminated.

2. Continuous Indicator:

When the LCD screen displays the CO % message, it will also illuminate the continuous icon, indicating the humidiﬁer is working continuously.

Reﬁll Warning: When the water level is too low, the heater will stop. The reﬁll icon will blink to indicate that the tank needs to be reﬁlled. After reﬁlling the water tank, you must press the RESET button to reactivate the unit.

4. Humidity Set Range:

Humidity may be set between 40 % RH and 85 % RH in increments of 5 %. If the humidity is set higher than 85 %, the LCD screen will display the CO % RH message, indicating the humidiﬁer is set to work continuously.

5. Humidity Display Range: The

humidity or ROOM display range is 40 % to 80 % RH. The LCD screen will display LO % if the humidity in the room is lower than 40 %. If the humidity in the room is higher than 85 %, the LCD screen will display HI %.

6. Setting Humidity:

Press UP or DOWN to change the humidity setting by 5 % up or down, respectively. The LCD screen will display the SET message and the digits on the screen will blink for two seconds until you change the setting. Once the humidity level is set, the LCD screen will display the current room humidity and the ROOM message.

1. When the water level is low, push the POWER button to turn the humidiﬁer OFF and unplug the humidiﬁer.

NOTE:

When the tank level is too low, the

humidiﬁer will turn OFF.

2. Lift the Water Tank and take it to the sink or a tub to reﬁll.

3. Turn the Water Tank over and unscrew the Tank Cap by twisting it counterclockwise.

4. Empty the Water Tank and reﬁll it with fresh, cool water. NEVER USE HOT

WATER.

5. Replace the Tank Cap by screwing it clockwise onto the Water Tank. Make sure that the tank cap is properly seated before screwing it back onto the tank to ensure a proper seal.

6. Place the Water Tank back onto the Base. Make sure the Water Tank is properly seated on the Base or the humidiﬁer will not work properly.

HUNTER WILL NOT ACCEPT RESPONSIBILITY FOR DAMAGE DUE TO WATER SPILLAGE.

7. Make sure the Power Button is set to OFF and plug the humidiﬁer into the wall outlet.

CAUTION: Never plug in the humidiﬁer while your hands are wet, as electric shock could occur.

NOTE: Let the humidiﬁer sit for one minute after reﬁlling the tank, before turning the power back ON.

8. Push the Power Button to turn the humidiﬁer ON. Adjust the setting as needed.

Base

Water Tank

Reﬁlling The Water Tank

ENGLISH

Reassembly Of Humidiﬁer Parts

Exhaust Grille

Medicine Cup

Water Tank

Boiler Cover

Boiling Chamber

Base

Tank Cap

Many regions have hard water with high concentrations of minerals. When water evaporates from the Care Free® Warm Mist Humidiﬁer, minerals may be left behind. These minerals can form a hard white scale which can be removed by following the cleaning instructions. The frequency of cleaning due to mineral build up varies depending on the quality of water you have. Failure to perform the necessary cleaning steps can damage the unit and affect performance.

NOTE:

The Water Tank, Tank Cap, Medicine Cup, Boiler Cover, Boiling Chamber, and Exhaust Grille are dishwasher safe in the top rack only.

1. Push the POWER button to turn the unit OFF (the indicator light will be OFF) and unplug the humidiﬁer.

2. Remove the Water Tank and carry it to a

sink or a tub. Unscrew the Tank Cap by twisting it counterclockwise and empty any water in the Water Tank.

3. CAUTION: HEATING ELEMENT MAY BE

EXTREMELY HOT.

Allow at least ﬁfteen (15) minutes for the

hot water in the Boiling Chamber to cool, after turning the humidiﬁer OFF, before moving the Base or removing the Boiling Chamber from the Base. Pull the Boiling Chamber away from the Base to remove the Boiling Chamber.

Cleaning The Humidiﬁer And The Water Tank

Boiler Cover

Boiling Chamber

Boiler

Base

4. Place the Boiling Chamber into an empty sink and carefully lift the Boiling Chamber Cover by pressing the Chamber Cover Release Tab. This will expose the Heater. Drain all water and rinse with cool, clean water. Use a soft brush or sponge to clean the Boiling Chamber and the Boiling Chamber Cover.

5. Pour one (1) cup of white vinegar into the Boiling Chamber and allow it to soak for 20-30 minutes. Rinse several times with cool, clean water. Wipe the Boiler clean if necessary.

6. Before reinstalling the Boiling Chamber, make sure the three metal pins in the Chamber are clean and completely dry. Place the Boiling Chamber Cover into the Boiling Chamber and slide the Chamber slowly back into place. Make sure the Chamber ﬁts properly in the Base.

7. To disinfect the Water Tank, create a solution of one (1) cup of white vinegar and one (1) gallon of clean water. Fill the Water Tank with the solution and allow it to soak for 20 minutes, occasionally swishing the solution to wet all interior surfaces. Empty the Water Tank completely and rinse with clean water several times. Reﬁll the Water Tank with cool, clean water and place it back on the humidiﬁer Base.

8. NEVER

use any metal or hard object,

which could cause scratching of the

humidiﬁer surface, to clean plastic parts.

NEVER

use gasoline, kerosene, glass cleaner, furniture polish, paint thinner, or other household solvents to clean any part of the humidiﬁer.

9. The Water Tank should be drained EACH DAY, rinsed, and reﬁlled with clean tap water.

10. To clean the exterior surfaces, use a solution of water and mild detergent with a damp cloth. Rinse the surfaces with clean water and dry with a cloth. Allow sufﬁcient time to dry before plugging the electrical cord back into the outlet.

11. Place the Water Tank back onto the Base and resume normal use.

Base

Water Tank

ENGLISH

+ 19 hidden pages

Hunter Fan 36205, 36207, 35207, 35205 User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual