Warm Mist Humidifier by Hunter Fan
Company. Please read and save these
instructions to receive maximum benefit
and performance from your humidifier.
Important Safety Instructions:
Read all instructions before using
this humidifier.
CAUTION: To avoid electrical
shock and/or fire, please read all
instructions before use.
1. This humidifier may not work properly
on an uneven surface. ALWAYS place
this humidifier on a firm, level, and
water resistant surface. ALWAYS place
the humidifier at least six (6) inches
away from walls and heat sources, such
as stoves, radiators, or heaters.
2. ALWAYS
that is out of the reach of children.
3. Before using the humidifier, extend
the cord and inspect for any sign of
damage. DO NOT use the product if the
cord has been damaged.
4. This product has a polarized plug as
a safety feature (one blade is wider
than the other). This plug will fit into
a polarized outlet only one way. If the
plug does not fully fit into the outlet,
reverse the plug. If it still does not
fit, contact a qualified electrician. DO
NOT
feature.
5. ALWAYS
humidifier when it is not in operation or
while it is being cleaned.
6. DO NOT
while it is in operation. Never move
the humidifier while there is water in
the tank. Empty the water tank, turn
the unit off, and unplug the unit before
moving.
7. In addition to routine maintenance
which may be required, this humidifier
requires seasonal cleaning. Refer to and
follow the instructions for CLEANING
THE HUMIDIFIER AND THE WATER TANK.
place the humidifier in an area
attempt to defeat or override this
unplug and empty the
tilt or move the humidifier
®
8. This unit was designed to be used with
distilled and/or tap water. DO NOT add
scented oils, perfumes or fragrance
additives to the water.
9. DO NOT
disassemble the Base while there is hot
water still in the unit. Allow a minimum
of fifteen (15) minutes cooling time
before moving or disassembling the
Base.
10. ALWAYS
the Water Tank.
11. To avoid the risk of electrical shock, DO
NOT
12. DO NOT
humidifier is for indoor use only.
13. DO NOT
on the back of the enclosure, the cord,
or the plug.
14. DO NOT
flammable vapors and liquids near the
humidifier.
15. DO NOT
place hands or face directly over the
Exhaust Grille while the unit is in
operation.
16. DO NOT
directly face a wall surface. Direct mist
aimed at a wall could cause damage,
particularly to wallpaper.
The Care Free® Warm Mist Humidifier has
a unique, patented design with several
innovative features:
• Removable Boiling Chamber
The detachable heater can be easily
removed for cleaning and maintenance.
• Humidification System
through a heating element which creates
warm mist to humidify the air. Stagnant
water in the reservoir is eliminated due
to minimal water quantity in the boiler
reservoir.
• Built-In Antimicrobial Properties
The plastic parts in this humidifier have
built-in antimicrobial properties to inhibit
the growth of bacteria, mold and fungi
that may affect these parts.
NOTE: The antimicrobial properties built-
into this humidifier do not extend to the
–
– Water is passed
–
Assembly Of Humidifier Parts
water, humidified air or users. Conduct
routine cleaning and maintenance based
upon use and individual conditions.
• No White Dust
Mist Humidifier produces no white
dust that can settle on furniture or be
inhaled.
NOTE: You may notice mineral deposits
accumulating in the tank base or on
other components. This is normal and
comes with regular usage conditions. If
you would like to remove these deposits
and maintain humidifier performance,
please see the section CLEANING THE
HUMIDIFIER AND THE WATER TANK.
• Dishwasher Safe
The Care Free® Warm Mist Humidifier
are top-rack dishwasher safe, except for
the powered base.
2. Select a location for your humidifier. The
location should be flat, hard, waterresistant, and at least six (6) inches
away from walls and sources of heat.
Mount the humidifier on a drip tray
if you are using the unit on a wood
surface or other surface which could be
damaged by accidental water spillage or
condensation.
HUNTER WILL NOT ACCEPT RESPONSIBILITY
FOR DAMAGE DUE TO WATER SPILLAGE.
3. Place the Base in the location you
selected. Take the Water Tank to a sink or
tub to fill with water.
4. Unscrew the Tank Cap by twisting it
counterclockwise and fill the Water Tank
with fresh, cool water. NEVER USE HOT
WATER.
6. Place the Water Tank back onto the Base.
Make sure the Water Tank is properly
seated on the Base or the humidifier will
not work properly.
HUNTER WILL NOT ACCEPT RESPONSIBILITY
FOR DAMAGE DUE TO WATER SPILLAGE.
7. Make sure the Power Button is set to
OFF and plug the humidifier into the wall
outlet.
CAUTION: Never plug in the
humidifier while your hands are wet, as
electric shock could occur.
NOTE: Let the humidifier sit for one minute
after refilling the tank, before turning the
power back ON.
8. Push the Power Button to turn the
humidifier ON. Adjust the setting as
needed.
5. Replace the Tank Cap by screwing it
clockwise onto the Water Tank.
In a very dry room, the HI setting should
be used to quickly achieve a comfortable level
of humidity. Once the room is at the desired
humidity level, you can turn the Adjustable
Humidistat down. We suggest you begin with
a middle setting and adjust the level using the
Adjustable Humidistat to suit your needs.
2.
Power Button – Sets humidity to
HIGH, LOW, or OFF.
– Allows you to
Push the Power Button on the base of the
unit AGAIN to turn the humidifier OFF. No
indicator light will be illuminated, which
indicates the unit has been turned OFF.
3. NiteGlo™ Night Light Button*
Illuminates with a soft blue glow.
Push the NiteGlo™ Button to turn the
light ON or OFF. The night light can be
operated even when the humidifier is
OFF.
*Not available on all models.
–
ENGLISH
Push the Power Button on the base of the
unit ONCE to turn the humidifier ON. A
green indicator light will be illuminated,
which indicates a HIGH setting.
NOTE:
It may take 2-3 minutes for the
humidifier to warm up and begin to release
warm mist.
Push the Power Button on the base of
the unit AGAIN to change the setting
to LOW. A yellow indicator light will
be illuminated, which indicates a LOW
setting.
1. When the water level is low, push the
POWER button to turn the humidifier OFF
and unplug the humidifier.
NOTE:
When the tank level is too low, the
humidifier will turn OFF and display a red
light.
Low Water Level
Light (Red)
2. Lift the Water Tank and take it to the
sink or a tub to refill.
3. Turn the Water Tank over and
unscrew the Tank Cap by twisting it
counterclockwise.
5. Replace the Tank Cap by screwing it
clockwise onto the Water Tank. Make
sure that the tank cap is properly seated
before screwing it back onto the tank to
ensure a proper seal.
6. Place the Water Tank back onto the Base.
Make sure the Water Tank is properly
seated on the Base or the humidifier will
not work properly.
HUNTER WILL NOT ACCEPT RESPONSIBILITY
FOR DAMAGE DUE TO WATER SPILLAGE.
7. Make sure the Power Button is set to
OFF and plug the humidifier into the wall
outlet.
4. Empty the Water Tank and refill it with
fresh, cool water. NEVER USE HOT
WATER.
CAUTION: Never plug in the humidifier
while your hands are wet, as electric shock
could occur.
NOTE: Let the humidifier sit for one minute
after refilling the tank, before turning the
power back ON.
8. Push the Power Button to turn the
humidifier ON. Adjust the setting as
needed.
Many regions have hard water with high
concentrations of minerals. When water
evaporates from the Care Free® Warm
Mist Humidifier, minerals may be left
behind. These minerals can form a hard
white scale which can be removed by
following the cleaning instructions. The
frequency of cleaning due to mineral build
up varies depending on the quality of
water you have. Failure to perform the
necessary cleaning steps can damage the
unit and affect performance.
NOTE:
The Water Tank, Tank Cap,
Medicine Cup, Boiler Cover, Boiling
Chamber, and Exhaust Grille are
dishwasher safe in the top rack only.
1. Push the POWER button to turn the unit
OFF (the indicator light will be OFF) and
unplug the humidifier.
2. Remove the Water Tank and carry it to a
sink or a tub. Unscrew the Tank Cap by
twisting it counterclockwise and empty
any water in the Water Tank.
3. CAUTION: HEATING ELEMENT MAY BE
EXTREMELY HOT.
Allow at least fifteen (15) minutes for the
hot water in the Boiling Chamber to cool
after turning the humidifier OFF before
moving the Base or removing the Boiling
Chamber from the Base. Pull the Boiling
Chamber away from the Base to remove
the Boiling Chamber.
sink and carefully lift the Boiling Chamber
Cover by pressing the Chamber Cover
Release Tab. This will expose the Heater.
Drain all water and rinse with cool, clean
water. Use a soft brush or sponge to clean
the Boiling Chamber and the Boiling
Chamber Cover.
5. Pour one (1) cup of white vinegar into the
Boiling Chamber and allow it to soak for
20-30 minutes. Rinse several times with
cool, clean water. Wipe the Boiler clean if
necessary.
6. Before reinstalling the Boiling Chamber,
make sure the three metal pins in the
Chamber are clean and completely dry.
Place the Boiling Chamber Cover into the
Boiling Chamber and slide the Chamber
slowly back into place. Make sure the
Chamber fits properly in the Base.
7. To disinfect the Water Tank, create a
solution of one (1) cup of white vinegar
and one (1) gallon of clean water. Fill the
Water Tank with the solution and allow
it to soak for 20 minutes, occasionally
swishing the solution to wet all
interior surfaces. Empty the Water Tank
completely and rinse with clean water
several times. Refill the Water Tank with
cool, clean water and place it back on the
humidifier Base.
humidifier surface, to clean plastic parts.
NEVER
use gasoline, kerosene, glass
cleaner, furniture polish, paint thinner,
or other household solvents to clean any
part of the humidifier.
9. The Water Tank should be drained EACH
DAY, rinsed, and refilled with clean tap
water.
10. To clean the exterior surfaces, use a
solution of water and mild detergent
with a damp cloth. Rinse the surfaces
with clean water and dry with a cloth.
Allow sufficient time to dry before
plugging the electrical cord back into the
outlet.
11. Place the Water Tank back onto the Base
and resume normal use.
If you do not plan to use your humidifier
for an extended period of time, such
as during the summer months, it is
important that you follow these instructions
to help prevent problems from developing
in the unit.
1. Clean your humidifier as outlined in
the CLEANING THE HUMIDIFIER AND
THE WATER TANK section.
2. Make sure all water is emptied from
Troubleshooting
• Problem: Humidifier not
misting.
Solution:
1. Make sure the unit is plugged in.
2. Check the circuit breaker or fuses.
3. Adjust the humidity level using the
Power Button and the Adjustable
Humidistat. Once the room reaches
the set humidity level, the humidifier
will turn OFF; this is normal.
4. Remove and refill the Water Tank.
5. Reposition the Water Tank on the
Base.
the tank and the hot and cold water
reservoirs.
3. Make sure the unit is completely dry.
4. Leave the Tank Cap off to expose the
Water Tank to air.
5. Pack the humidifier in the original
carton and store it in a cool, dry
place.
• Problem: Humidity output and
water usage decreased.
Solution:
1. Check the Adjustable Humidistat and
Power Button to make sure they are
set to the desired humidity level.
2. Clean any components that have
mineral build-up. Refer to the section
on CLEANING THE HUMIDIFIER AND
THE WATER TANK.
ENGLISH
If you have questions or problems, please call 1-888-830-1326 for assistance before
returning the unit to the retailer.