Hunter Fan 30115 User Manual
TM
®
SINCE 1886
True HEPA Air Purifier
QuietFlo
0
1
2
3
QuietFlo™
115 (Model 30115)
These air purifiers use Model 30938 replacement HEPA filters.
These air purifiers use Model 30907 replacement pre-filters.
WWW.HUNTERFAN .COM
FORM 41477-01 Rev 1-29-2001 © 2001 HUNTER FAN CO.
IMPOR TANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING THIS AIR
PURIFIER AND SAVE THESE IMPORTANT
INSTRUCTIONS
1. This Air Purif ier is designed for use on a flat, lev el surface and may not work properly on
an uneven surface. ALWAYS place this Air Purifier on a firm, level surface. ALWAYS
place the Air Purifier at least six (6) inches away from walls and heat sources such as
stoves, radiators, or heaters.
2. Place the Air Purifier in an area that is out of the reach of children.
3. Before using the Air Purifier, extend the cord and inspect for any signs of damage. DO
NOT use the product if the cord has been damaged.
4. This product has a polarized plug (one blade is wider than the other) as a safety feature.
This plug will fit into a polarized outlet only one way. If the plug does not fit fully into
the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT
attempt to defeat or override this safety feature.
5. ALWAYS UNPLUG the Air Purifier when it is not in operation, while the filter is being
changed, and while it is being cleaned.
6. DO NOT tilt or move the Air Purifier while it is in operation. Shut off and unplug
before moving.
7. DO NOT immerse the Air Purifier in water as permanent damage will occur. Refer to
and follow the CLEANING AND FILTER REPLACEMENT instructions.
Introduction
Thank you for purchasing the
pany . Y ou hav e purchased our latest de velopment in portable Air Purification Systems. This
system has been developed to improve the quality of the air you breathe.
QuietFlo™
Our
quickly and effectively removing dust, smoke, and pollen particles. Room air is pulled in
through the front grille and cleaned across the HEP A filter. Clean air is then released out the
top grille.
The HEPA filter will remove 99.97% of particles 0.3 microns in size from air that passes
through the filter.
The activated carbon pre-filter helps remove cooking, smoke, and pet odors from the air. It
also traps lint, hair, and large particles, which helps impro ve the life and performance of the
HEP A f ilter.
FORM 41477-01 Rev 1-29-2001 2 © 2001 HUNTER FAN CO.
True HEPA Air Purifier out performs other air purification systems by
QuietFlo™
True HEPA Air Purifier from Hunter Fan Com-
Setting Up Your Air Purifier
1. Remove your air purifier from the box and take it out of the clear plastic protective bag.
2. Place your
3. Before turning the Air Purif ier ‘on’, you need to open the front grille. To release the front
grille, press the tabs until the front grill slides easily over the tabs. Refer to Figure 1.
4. The HEPA filter is already installed in the correct position, but you need to confirm that
it is fully inserted. To remove, grasp the edge of the filter frame and pull it forward.
Notice the orientation of the flaps and seal, which should be pressed firmly into the filter
opening.
5. The carbon pre-filter is mounted inside the front grille with "hook" tape. Confirm that it
covers the grille vents. Refer to Figure 2.
6. Place the filter installation reminder sticker on the inside edge of the front grille. Circle
the month and write the year of installation for the pre-filter and HEPA filter.
7. Replace the filter and front grille. Be sure that the bottom grille tabs are in position first,
and then push the top of the grille forward until it is closed. The unit is now ready for
normal operation. NOTE: This unit will not operate unless the door is placed in the correct position.
8. Plug the unit into a 120V electrical outlet.
QuietFlo™
Air Purifier on a firm, flat surface.
AIR PURIFIER PARTS
QuietFlo™ 115
FIGURE 1
QuietFlo™ 115
FIGURE 2
FORM 41477-01 Rev 1-29-2001 3 © 2001 HUNTER FAN CO.
Loading...