Hunter 99179, 99180, 99181 User Manual
Original Accessory
Original Accessory
Control and Canopy
Control and Canopy
Installation Manual
Models 99179, 99180, 99181
M0093-01 • 02/03/14
BEFORE YOU BEGIN
Read entire installation instructions carefully before
beginning installation and save these instructions.
Have the fan manual available for reference.
If you are installing multiple remote-controlled fans
on the same circuit breaker,
you may need to perform a few extra steps to prevent
interference or faulty operation of your remote controls.
Go to www.HunterFan.com/FAQs and click “How do I properly
install multiple remote-controlled fans?” for more information.
Note: A 12 inch or longer downrod (sold separately) is required for
the installation of the Original Control and Canopy Accessory Kit.
1.888.830.1326
READ AND SAVE THESE INSTRUCTIONS
This product conforms to UL Standard 507.
WARNINGS
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This device complies with RSS-210 of Industry Canada. Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of
the device.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna, Increase the separation between the equipment
and receiver, Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected. Consult the dealer or an experienced radio/TV technician for
help. Note: Any changes or modications to the transmitter or receiver not expressly
approved by Hunter Fan Company may void one’s authority to operate this remote control.
2
M0093-01 • 02/03/14
Turn Power
OFF
WHICH ASSEMBLY METHOD WILL I USE?
Canopy
Screw
1.888.830.1326
If your fan has not been installed, follow
the TYPE-A ASSEMBLY INSTRUCTIONS
on page 4.
Canopy
Screw
If your fan is already installed and the
canopy is held by three screws near
the ceiling as shown, follow TYPE-C
ASSEMBLY INSTRUCTIONS on page 5.
If your fan is already installed and the
canopy is held by two screws near the
downrod as shown, follow the TYPE-B
ASSEMBLY INSTRUCTIONS on page 4.
3
M0093-01 • 02/03/14
Loading...