Hunter 33223 Owner's Manual

Français

Consulter la page 15

Español

Vea la página 8

ENGLISH

See page 2

www.hunterfan.com

The Care Free®

Evaporative Humidier with Permawick

Models 33223, 37223

Read and Save These Instructions

How The Care Free® Evaporative Humidier Works

Important Safety Instructions: Read all

instructions before using this humidier.

1. This humidier may not work properly on an uneven surface. ALWAYS place this humidier on a rm, level, and water resistant surface.

ALWAYS place the humidier at least six (6) inches away from walls and heat sources such as stoves, radiators, or heaters.

2. ALWAYS place the humidier in an area that is out of the reach of children.

3. Before using the humidier, extend the cord and

inspect for any signs of damage. DO NOT use the product if the cord has been damaged.

4. This product has a polarized plug (one blade is wider than the other) as a safety feature. This plug will t into a polarized outlet only one way. If the plug does not t fully into the outlet, reverse the plug. If it still does not t, contact a qualied electrician.

DO NOT attempt to defeat or override this safety

feature.

5. ALWAYS UNPLUG AND EMPTY the humidier when it is not in operation or while it is being cleaned.

6. DO NOT tilt or move the humidier while it is in operation. Never move the humidier while there is water in the tank. Empty the water tank, turn

off, and unplug the unit before moving.

7. In addition to routine maintenance which may

be required, this humidier requires seasonal

cleaning. Refer to and follow CLEANING THE HUMIDIFIER AND THE WATER TANK

instructions.

8. This unit is designed to be used with distilled and/or tap water. DO NOT add scented oils, perfumes, or fragrance additives to the water.

Thank you for purchasing The Care Free® Humidier Evaporative Humidier by Hunter Fan Company. Please read and save these instructions to receive the maximum benet and performance from your humidier.

The Care Free® Humidier Evaporative Humidier has a unique patented design with several innovative features:

• Low Maintenance – Other humidiers have paper lters that need to be replaced every few months. Our exclusive PermaWick™ lter saves

time and money. It’s designed to last season after season, saving up to $45 a year. No wet paper odors either.

• Regulated Release™ System – By dispersing water from the top of the PermaWick™ lter, stagnant water around the PermaWick™ lter

is eliminated, and the buildup of mineral residue

that can clog the lter and impede performance is eliminated. NOTE: The lter has a coating on the wick which may make it appear old or used, but is

actually new.

• Built-in Antimicrobial Properties – The plastic

parts and the PermaWick™ lter have built-in

antimicrobial properties to inhibit the growth of bacteria, mold and fungi that may affect these parts.

NOTE: This product contains antimicrobial properties which are built-in to inhibit the growth of bacteria which may affect the plastic and

PermaWick™ lter in the humidier. These properties do not extend to the water, humidied

air or users. Conduct routine cleaning and maintenance based upon use and individual conditions.

• No White Dust – The Care Free® Humidier Evaporative Humidier produces no white dust

that can settle on furniture or be inhaled.

ENGLISH

Humidier Parts

Figure 1

Power / Speed

Control

Power Light or NiteGlo™ Night Light

Control

Water Tank

Tank Cap

Air Inlet Grill

Main Housing

Water Dispersion Tray

PermaWick™ Filter

Water Diffuser Cap

Base

Wick Supports

PermaWick™ Filter

Easy Tote Handle

NOTE: You may notice mineral deposits accumulating in the tank base or on the PermaWick™ lter. This is normal and does not affect performance. If you would like to clean these deposits away, please see CLEANING THE HUMIDIFIER AND WATER TANK.

Using Your Humidier

Figure 2

Power Light or NiteGlo™ Night Light

Control

Power/Speed Control

Power Light: The light will be illuminated when the power is on.

Fan Power/Speed Control: Turns the humidier

‘ON’ and ‘OFF’. The power should always be

off before unplugging the humidier, moving the humidier, or relling the water tank.

NiteGlo™ Night Light Control: Turns the night light ‘ON’ and ‘OFF’. The night light can be turned

on even if the humidier fan is turned off.

Humidier Features

1. Remove The Care Free® Evaporative Humidier

from its packaging. Read and Save the

Instructions.

2. Place the humidier on a hard, at, water resistant surface. Always place the humidier at least six (6) inches away from walls and sources

of heat.

3. Lift the main housing to conrm that the PermaWick™ lters are placed upright in the slots. Replace the main housing. (See Figure 1.)

4. Remove the water tank and take it to the sink or tub to ll.

5. Turn the tank upside down and unscrew the tank cap by turning it counterclockwise. Fill the water tank with cool water and replace the tank cap (Never use hot water). Be sure not to overll the tank as water damage may occur to furniture or ooring due to spillage.

HUNTER WILL NOT ACCEPT RESPONSIBILITY FOR DAMAGE TO PROPERTY CAUSED BY WATER SPILLAGE.

6. Carry the tank back to the humidier. Turn the tank upright and place it on the humidier. Be sure that the tank is seated properly in the base. If the tank is properly located on the base, you will see air bubbles owing up into the tank.

7. With the power control knob in the ‘OFF’ position, plug the humidier into the wall.

CAUTION: Never plug in the Humidier while your hands are wet as Electric Shock could occur. Place the full tank on the unit and allow the water to ll the bottom tray. The water is at the proper level in the bottom tray when the tanks stops bubbling.

Run the unit on “HI” speed for 11⁄2 minutes for optimum pump operation. Set the unit to the desired speed.

8.Use the power control knob to turn the humidier

‘ON’ by selecting a speed setting.

9. Use the control to turn the night light off and on. The night light can be operated even if the

humidier fan is turned ‘OFF’.

ENGLISH

Cleaning the Humidier and the Water Tank

Relling the Water Tank

1. When the water tank level is low, turn the humidier ‘OFF’, and unplug.

2. Remove the tank and take it to the sink or tub to rell.

3. Turn the tank upside down and unscrew the tank cap by turning it counterclockwise. Empty the tank, rell with fresh cool water (never use hot water), and replace the tank cap. Be sure not to overll the tank as water damage may occur to furniture or ooring due to spillage.

HUNTER WILL NOT ACCEPT RESPONSIBILITY FOR DAMAGE TO PROPERTY CAUSED BY WATER SPILLAGE.

4. Carry the tank back to the humidier. Turn the tank upright and place it on the humidier. Be sure that the tank is seated properly in the base. If the tank is properly located on the base, you will see air bubbles owing up into the tank.

5. Place the full tank on the unit and allow the water to ll the bottom tray. The water is at the proper level in the bottom tray when the tanks

stops bubbling. Run the unit on “HI” speed for

11⁄2 minutes for optimum pump operation. Set

the unit to the desired speed.

Many regions have hard water with high

concentrations of minerals. When water evaporates from The Care Free® Evaporative Humidier,

minerals may be left behind. These minerals can form a hard white scale which can be removed by following the cleaning instructions. The frequency of cleaning due to mineral build up can vary depending upon the quality of water you may have. Refer to Figure 1 for part names.

1. Turn the humidier ‘OFF’ and unplug the unit.

2. Lift the main housing and remove the water

dispersion tray and the PermaWick™ Filters. The motor is attached to the main housing. Do not place the motor near water. Do not use a wet towel on the motor or motor housing as electrical shock may

occur.

3. The PermaWick™ Filter should be cleaned in a

vinegar and water solution to remove any mineral

buildup. Place in a solution of one (1) gallon of water and eight (8) ounces of undiluted white vinegar. Allow the lter to soak for 20 minutes.

4. After soaking, rinse it several times with clean water. Place the PermaWick™ Filter in a location

where it can drip dry while you clean the other

parts of your humidier.

5. Remove the water tank from the base and empty any water that is left in the tank. Reseat the main housing onto the base of the humidier and ll the base with a mixture of one (1) gallon of water and eight (8) ounces of vinegar. Allow to sit for 20

minutes.

6. After soaking, remove the main housing and

wipe with a dry, soft cloth or sponge to remove any mineral build up around the bottom. Rinse the

base with clean water several times. Do not rinse

the main housing. If you are planning on storing

the humidier, be sure the base is completely dry.

7. Fill the water tank with one (1) gallon of water and

eight ounces of undiluted white vinegar. Replace

the tank cap and shake the tank vigorously until all interior surfaces of the tank have been exposed to the water/vinegar mixture.

8. Empty the tank of the water/vinegar mixture.

Rinse it several times with clean water and then

replace the tank cap. If you are planning on storing the humidier,dry it inside and out, leaving the cap off to allow the tank to completely dry.

Continue to clean the other parts of your

humidier.

If you have any additional questions or problems with your Care Free® Humidier, please call 1-888-8301326 (CAN 1-866-268-1936) or contact us over the Internet at www.hunterfan.com. Refer to Figure 1 for part names.

Service Parts

Figure 3

Water Diffuser Cap

Tab

9. Remove the water diffuser cap by squeezing the two tabs as shown in Figure 3. Rinse the cap in clean water to remove any debris. If

the cap contains hard water residue, soak it in a mixture of one (1) quart of water and two (2)

ounces of vinegar for 20 minutes. Rinse well

and reinstall the water diffuser cap. Do not expose motor or other electrical components to

water.

10. Wipe the surfaces of the main housing with a

soft cloth.

Water Diffuser Cap 86249 Water Dispersion Tray 94099

Base 94105

Water Tank 95857 Power/Speed Control 76737 Tank Cap 94104 PermaWick™ Filter 94124

11. Once all the parts are clean, reassemble

the humidier, and follow the USING YOUR HUMIDIFIER to continue use.

If you are storing the humidier, make sure the parts are completely dry, reassemble, and store in a dry location.

Humidier FAQ

1. When I turn my humidier on, it does nothing but

hum.

Sometimes mineral deposits from the water can

get trapped in the impeller of the humidier. Fol

low the cleaning instructions on page 5.

2. I just bought my humidier and I am setting it up, but my lter is lthy right out of the box.

Your lter has been treated with an anti-microbial agent that can give the appearance that the lter

has mineral deposits on it.

3. My humidier is starting to sound like a waterfall when I run it. What should I do?

Follow the cleaning instructions on page 5.

Your humidier lter or water diffuser cap may

be clogged.

4. I used to add chemicals to my water such as

water softeners or anti-microbial treatments. Do I need these with my Hunter humidier?

There is no need for additives with your Hunter

humidier. Anti-microbial properties have already

been molded into the plastic in the unit. Adding these type of treatments could cause damage

to the pump systemlter or inside of the unit, it is

time to be cleaned.

5. If the unit is “Care Free”, why do I have to

clean it?

All humidiers require some maintenance. To keep your Hunter humidier running it is

necessary to clean minerals deposits from the

lter and pump system.

6. How do I clean my Hunter humidier and how

often?

Refer to page 5 for cleaning instructions. Check

your humidier lters periodically and when you start to see crystal like formations coating the lter or inside of the unit, it is time to be cleaned.

To learn more about Hunter Fan Company products, please see our web page at:

www.hunterfan.com

Other Home Comfort Products from Hunter

Hunter Original

QuietFlo™

True HEPA Air Purier

Programmable

Thermostat

+ 14 hidden pages

Hunter 33223 Owner's Manual

Specifications and Main Features

Frequently Asked Questions

User Manual