![](/html/ee/ee32/ee32da295b87e6ee30d032fc1bf1f4efe7a46c83da34437fd6ca87c08f27ae5b/bg1.png)
The DSP 3-Axis Color DOMED camera HTC-11C48D & HTC-11C48DDN incorporate
advanced 1/3” high performing CCD Sensor and digital signal processor (DSP) circuit.
HTC-11C48D(DN) (NTSC) Color Camera incorporates the 1/3" CCD sensor 250,000
pixels
HTC-11C48D(DN) (PAL) Color Camera incorporates the 1/3" CCD sensor 291,000
pixels
GAIN CONTROL(GC)- ON/OFF Switch
The adoption of an AUTOMATIC GAIN CONTROL (AGC) provides clear image in low
light condition.
ELECTRONIC SHUTTER(ES)- ON/OFF Switch
The 3-Axis Color DOMED Camera HTC-11C48D & HTC-11C48DDN incorporate the
Electronic Shutter up to 1/100,000.
BACK LIGHT COMPENSATION (BLC)—ON/OFF Switch
As you take a picture with strong light behind the subject, the picture would be looked
very dim on the subject.
In this case, you should select BLC ON, the AES should be in ON position.
NOTE: When you select BLC ON, the AES should be in ON position.
LENS
The 3-Axis Color DOMED Camera HTC-11C48D & HTC-11C48DDN include a
2.8~11mm board lens applications.
3-AXIS ADJUSTMENTS
The 3-Axis camera maximum rotation and placement angel diagrams are shown in the
following.
INSTALLATION PROCEDURE
Camera will be installed as below when Ex-factory
○
1 Horizontal Rotation: 180°
![](/html/ee/ee32/ee32da295b87e6ee30d032fc1bf1f4efe7a46c83da34437fd6ca87c08f27ae5b/bg2.png)
STEP 1: Use screw driver to tight up 4 attached 1/32” x1” screws first, then refit the
dome cover.
STEP2: Complete installation
1. 3-Axis Dome camera
2. 1/32” x1” screws
3. Plastic dome cover
4. BNC cable
5. Power cable
MORE THAN 48 dB (AGC OFF)
ON/OFF Switch; Range 1/50 (1/60)Up to 1/100,000
2.8~11 mm Varifocal lens at F1.4
DC 180 mA for DC 12V/ AC 2.4 W for AC 24V
*SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.