Hummer H-212 User Manual
H-212
Notice
Please read this user´s manual carefully before installation to get the cooler´s best
performance by optimized installation. NOX xtreme is not responsible for any damage to the
product or injury caused by incorrect installation or user´s carelessness. The cooler may
cause an interference with few motherboards and if you face an interference between
Hummer cooler and your motherboard, please stop installing the cooler. Be sure to be careful
not to hurt yourself by the sharp fins while installating & disassembling the cooler. Do not
move the cooler around after the installation to prevent CPU damage. Please, do not use the
cooler for any other usage apart from the original purpose
.
Warranty
For your warranty claims, please contact Nox Xtreme overseas distribution partners in your
country. Find de distribution partner list at www.nox-xtreme.com
Warranty: 2 years from purchasing date.
(Depending on the laws of each country)
URL: www.nox-xtreme.com
E-mail: support@nox-xtreme.com
1) Cooler x 1
2) AMD clip x 1
3) Intel LGA 115X clip x 2
4) Intel LGA 2011 clip x 2
5) Screw x 4
6) Intel LGA 115X Backplate x 1
7) Thermal Grease x 1
8) Mounting second fan x 2
Components description
H-212
EN
1) Place the hook for the fan
on the cooler.
2) Apply pressure to pass the
wire through the fan.
3) Insert the end of the hook
into the holes of the fan.
Second fan assembly
1 2 3
5 6 7
2 3 4
1
8
2. Put the
backplate onto
the back of
motherboard
4. Put the heatsink
onto the
processor and
hook the vertical
clip
5. Connect the
fan cable to the
motherboard
3. Apply the
thermal paste
on CPU
1. Attach the LGA
115X metal clips
onto heatsink base
2. Apply the
thermal paste on
CPU
4. Connect the fan
cable to the
motherboard
3. Put the heatsink
onto the processor
and hook the vertical
clip
1. Attach the AMD
metal clips onto
heatsink base
Intel LGA 1150 / 1151 / 1156 / 1155 installation
Intel LGA 2011 installation
AMD FM2 / FM1 / AM4 / AM3+ / AM2+ / AM2 installation
21 3 4 5
1 2 3 4
2. Apply the
thermal paste on
CPU
4. Connect the fan
cable to the
motherboard
3. Put the heatsink
onto the processor
and hook the vertical
clip
1. Attach the LGA
2011 metal clips
onto heatsink base
1 2 3 4
Loading...