This manual is provided as an aid in setting up, operating and maintaining the
instrument. It does not supply the necessary information required to perform
the ASTM test. This information is copyrighted, and must be obtained from the
American Society for Testing and Material (ASTM).
http://www.astm.org
or by calling: 610-832-9585
K42000 & K42090 POWERTROL HEATER
INSTRUCTIONS, FOR USE
1. Plug heater into receptacle of the proper electrical characteristics
(K42000 - 115V) & (K42090 - 230V)
2. Turn unit on by turning knob (On/Off Switch) clockwise
3. Vary heat by turning knob clockwise from 0 to full.
4. To energize receptacle for stirrer or an accessory,
depress the front panel switch to ON.
STORAGE PROCEDURE
This laboratory test instrument consists of Electrical and Mechanical components.
Storage facilities should not be subject to extremes of high and low temperatures or
extremes of high and low moisture conditions. Storage facilities ·should be consistent
with an indoor laboratory environment.
NOTE: Unit is shipped in corrugated cartons and if long term storage is anticipated,
repacking with water resistant packing is recommended to insure a safe condition for the
equipment.
Electric Heater with Rheostat
Flash-Point Platform
Test Burner
Flash Cup
Thermometer
H-2085.1
H-2085P
H-2112
H-2060
H-2600.11F
K42000 Wiring Diagram
COMMENTS
SIGNAL NAME
REVISION
NUMBER
DRAWING
T1-4284-116-10EACH
MOLDED PLUG
S1-2284-116-25E
T1-3284-116-10EACN
T1-6284-116-10EACG
284-516-061
MOLDED PLUG
284-516-061
MOLDED PLUG
T1-3284-116-10E
T1-1284-116-10E
284-516-061
WIRE DATATERMINATION DATA
T1-4284-116-10E
T1-5284-116-10EHEATER L1
T1-2284-116-10EHEATER L2
284-216-25E
284-116-10H
284-116-10H
001282-016-016BK72.0W1
NO.TYPECOLORLENGTHPOINT 1TYPEPOINT 2TYPE
001282-016-016WH72.0W1
001282-016-016GN72.0W1
002282-016-B02BK6.0J1-2
003282-016-W02WH6.0J1-1
004282-016-G02GN6.0J1-3
005282-016-B02BK6.0S1-3
006282-014-W18WH11.0HR1-1
007282-014-W18WH11.0HR1-2
WIRE LIST: POWERTROL HEATER, 115 VOLT
SHEET 2 OF 2K42000WDA
K42090 Wiring Diagram
COMMENTS
SIGNAL NAME
REVISION
NUMBER
DRAWING
T1-4284-116-10EACL1
MOLDED PLUG
S1-2284-116-25E
T1-3284-116-10EACL2
T1-6284-116-10EGROUND
284-516-061
MOLDED PLUG
284-516-061
MOLDED PLUG
T1-3284-116-10E
T1-1284-116-10E
284-516-061
WIRE DATATERMINATION DATA
T1-4284-116-10E
T1-5284-116-10EHEATER L1
T1-2284-116-10EHEATER L2
284-216-25E
284-116-10H
284-116-10H
001282-016-017BK72.0W1
NO.TYPECOLORLENGTHPOINT 1TYPEPOINT 2TYPE
001282-016-017WH72.0W1
001282-016-017GN72.0W1
002282-016-B02BK6.0J1-2
003282-016-W02WH6.0J1-1
004282-016-G02GN6.0J1-3
005282-016-B02BK6.0S1-3
006282-014-W18WH11.0HR1-1
007282-014-W18WH11.0HR1-2
WIRE LIST: POWERTROL HEATER, 230 VOLT
SHEET 2 OF 2K42090WDA
Warranty
Humboldt Mfg. Co. warrants its products to be free from defects in material or
workmanship. The exclusive remedy for this warranty is Humboldt Mfg. Co., factory
replacement of any part or parts of such product, for the warranty of this product please
refer to Humboldt Mfg. Co. catalog on Terms and Conditions of Sale. The purchaser is
responsible for the transportation charges. Humboldt Mfg. Co. shall not be responsible
under this warranty if the goods have been improperly maintained, installed, operated
or the goods have been altered or modified so as to adversely affect the operation, use
performance or durability or so as to change their intended use. The Humboldt Mfg. Co.
liability under the warranty contained in this clause is limited to the repair or replacement
of defective goods and making good, defective workmanship.
Humboldt Mfg. Co.
875 Tollgate Road
Elgin, Illinois 60123 U.S.A.
U.S.A. Toll Free: 1.800.544.7220
Voice: 1.708.456.6300
Fax: 1.708.456.0137
Email: hmc@humboldtmfg.com
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.