human care 1405, 1400 Operating Manual

OPERATING MANUAL

COMPONENTS

1 x Seat 4 x Legs

WARNINGS

ASSEMBLY/USAGE LOOK SHOWER SEAT
Model #1405

DO NOT USE ANY PIECE IF THERE ARE ANY CRACKS OR DAMAGED
COMPONENTS

250lb / 113.4kg

Ensure legs are locked in before

sitting.

CARE AND USE

DO NOT use chlorine bleach or

abrasive cleansers. To clean, wipe
down with a damp cloth using a
mild detergent only. Rinse well
after each use.

Ensure legs are adjusted to
be level before use to avoid
possible injury.

Supervision or assistance when
using seats is recommended for
users with limited mobility.

DO NOT stand on seat. Legs
must firmly touch the ground
when seated.

Periodically check the legs to
ensure that all push buttons
protrude fully through the
adjustment holes in the legs.

Only use on tub/shower floors
that are wide enough to ensure
stability of all four legs.

READ ALL WARNINGS CAREFULLY

KEEP THIS INFORMATION FOR FUTURE

REFERENCE

DO NOT exceed weight capacity!

Increase safety by using a slip

resistant bath mat under the seat.
Shower seats are not to be used
for assistance in entering/exiting
the bathtub. Use a bathtub safety
rail to assist you in sitting down if
necessary.

Human Care Canada Inc. All rights reserved. This manual may not be reproduced in part
or in whole without the written permission of the publisher. (REV: SEPTEMBER 2013)

Ensure your weight is evenly
distributed when sitting.
Improper or uneven loading may
result in the bath seat tipping over
and/or falling.

Use only authorized parts/
accessories with your shower
seat.

SOLD SEPARATELY

OPERATING MANUAL

ASSEMBLY

IMPORTANT: ENSURE THAT ALL PUSH BUTTONS “CLICK” INTO POSITION. DO NOT USE PRODUCT IF PUSH
BUTTONS ARE DAMAGED IN ANY WAY.

ASSEMBLY/USAGE LOOK SHOWER SEAT
Model #1405

STEP 1

Flip over seat and insert legs into holes
in bottom of seat, ensuring you hear the
white button “click” into place.

ADDING AN ARMREST / SMALL BACKREST

ITEM SOLD SEPARATELY

IF YOU HAVE ANY PROBLEMS OR REQUIRE
ASSISTANCE WITH THE PRODUCT PLEASE
CALL:

613-723-6734

HUMAN CARE CANADA INC.

10-155 Colonnade Road
Ottawa, ON K2E 7K1

DISHWASHER
SAFE PLASTIC

STEP 2

Push in brass coloured button and
slide inner tube up or down to adjust to
desired height. Ensure button “clicks”
into place.

Add armrest to side holes on seat by pushing clips downwards into holes until
they “click” in. The armrest can be added to either side of the seat.

NOTE: When the bath seat is turned, the armrest acts as a small backrest.

STEP 3

Turn over seat after all legs installed and
verify they are evenly adjusted. Do not
use if seat is not level.

Human Care Canada Inc. All rights reserved. This manual may not be reproduced in part
or in whole without the written permission of the publisher. (REV: SEPTEMBER 2013)