human care 1250, 1255 Operating Manual

OPERATING MANUAL

ASSEMBLY/USAGE BATH SAFETY RAILS
FOR MODELS: 1250 Regular / 1255 Inverse

WARNINGS

250lb / 113.4kg

Never overtighten the bath safety rail as
this could cause damage to the bathtub
or the rail itself.

CARE AND USE

DO NOT use chlorine bleach or abrasive
cleansers. Use soap and water or a mild
detergent. Rinse well before using it
again.

ASSEMBLY

Before installing your bath
safety rail, make sure your
bathtub is dry and dirt free. The
bath safety rail can be mounted
at either end of the tub.

Locate the flattest section of the
inner and outer bathtub wall.
AVOID curves in the bathtub
where bath safety rail cannot
properly grip.

Never install your bath safety rail on a
plastic or fiberglass tub. The tub rail will
not fit on curved bathtubs.

Periodically check the bath safety rail
to ensure the rubber pads are securely
affixed to the bath safety rail.

Loosen adjustment knob until
bath safety rail is wide enough to
fit tub. Place bath safety rail on
tub with adjustment knob facing
outwards. Turn adjustment knob
clockwise to tighten.

Re-tighten your bath safety rail once a
week to maintain proper installation.

Verify the bath safety rail is firmly in
place before each use (should stay in
place when pressure applied or when
pulled).

Test mounting by pulling bath
safety rail forward, back and side
to side. If bath safety rail moves,
loosen knob, check that the
knob is not threaded or the pads
loose. If okay, replace at desired
position and retighten.

DO NOT exceed weight capacity!

DO NOT USE THE BATH SAFETY
RAIL IF THERE ARE ANY CRACKS
OR DAMAGED COMPONENTS!

READ ALL WARNINGS

CAREFULLY

KEEP THIS INFORMATION FOR

FUTURE REFERENCE

CAUTION:

Verify the bath safety rail is firmly
in place before use. If bath safety
rail is not securely in place, it
may come loose causing injury.

HUMAN CARE CANADA INC.
10-155 Colonnade Road
Ottawa, ON K2E 7K1

MADE IN CANADA

Human Care Canada Inc. All rights reserved. This manual may not be reproduced in
part or in whole without the written permission of the publisher. (REV: JULY 2013)

IF YOU HAVE ANY PROBLEMS OR REQUIRE
ASSISTANCE WITH THE PRODUCT PLEASE
CALL:

613-723-6734