HUIZHOU GAOSHENGDA TECHNOLOGY W7ZM1100 User Manual

Hui Zhou Gaoshengda Technology Co., LTD W7ZM1100

PAGE 1 OF 3

Version 1.0

WIFI Module
IEEE 802.11 b/g/n

1T/1R

Model Number:

W7ZM1100

The W7ZM1100 is a 2.4GHz WIFI 1×1 module. The WLAN operation supports 20MHz,40MHz channels for data
rates up to 150Mbps. It fully complies with IEEE 802.11 b/g/n feature rich wireless connectivity at high
standards,delivers reliable,cost-effective, throughput from an extended distance.

Product Name

WIFI Module

Model

W7ZM1100

Standard

802.11 b/g/n

Interface

USB

Data Transfer Rate

1,2,5.5,6,11,12,18,22,24,30,36,48,54,60,90 and maximum of 300Mbps

Modulation Method

DQPSK,DBPSK,CCK(802.11b)
QPSK,BPSK,16QAM,64QAM with OFDM (802.11g)
QPSK,BPSK,16QAM,64QAM with OFDM (802.11n)

Frequency Band

2412~2462 MHz

Operation Mode

Infrastructure

Security

WEP, TKIP, AES, WPA, WPA2

Operating Voltage

3.3V±10%

Current Consumption

＜1000mA

Antenna Type

PIFA

Operating
Temperature

0 ~ 60°C ambient temperature
Storage Temperature

-40 ~ 80°C ambient temperature

Humidity

5 to 95 % maximum (non-condensing)

Product Features

Product Description

◆ Complies with IEEE 802.11b/g/n for 2.4GHz Wireless LAN.

◆One transmit and One receive path(1T1R)

◆ Works with all existing network nfrastructure.

◆Capable of up to 128-Bit WEP Encryption.

◆Freedom to roam while staying connected.

◆ UP to 150Mbps High-Speed Transfer Rate in 802.11n mode of operation.

◆ Operating Systems：Android,Linux,Win7,XP

◆ Low power consumption.

◆ Easy to install and configure.

◆ High speed USB 2.0 interface

◆ ROHS compliant

Product Specification

Hui Zhou Gaoshengda Technology Co., LTD W7ZM1100

PAGE 2 OF 3

Version 1.0

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Caution: The user is cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.

If power exceeds the limit and the distance（Over 20cm distance in actual use between the device and user） is
compliant with the requirement

FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part
of your body.

The device must be professionally installed

The intended use is generally not for the general public.It is generally for industry/commercial use.
The connector is within the transmitter enclosure and can only be accessed by disassembly of the transmitter that is not

normally required. the user has no access to the connector.
Installation must be controlled. Installation requires special training

Canada Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the
device.

L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux
CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes :

1)L'appareil ne doit pas produire de brouillage;

2)L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.