HUIZHOU GAOSHENGDA TECHNOLOGY BT02B150 User Manual

PRODUCTS USERMANUAL

Bluetooth 4.0 Module

BT02B150

Model Number:

BT02B150

Product Description

GSD BT02B150 is to specify the product requirements for Bluetooth 4.0 Module.
This Card is based on Broadcom BCM20705 chipset that can support
BT2.1+EDR/BT3.0+HS and BT4.0+EDR.

Product Features

◆ Bluetooth 4.0+EDR compliant

◆Programmable output power control meets Class1,Class2,or Class3

requirements.

◆Use supply voltages up to 5.5V.

◆Supports Broadcom SmartAudioTM,wide-band speech,SBC codec,and packet

lose concealments.

◆Ultra-low power consumption.

◆ARMTDMI-STM-based microprocessor with integrated ROM and RAM

◆Supports mobile and PC applications without external memory.

PAGE 1 OF 1

Version 1.0

PRODUCTS USERMANUAL

BT02B150

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference

to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interferencereceived, including interference that
may cause undesired operation.

Caution:

Any changes or modifications not expressly approved by the party responsible for
compliance could void

FCC Important Notes:
(1)
FCC Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.

The devices must be installed and used in strict accordance with the manufacturer’s
instructions as described in the user documentation that comes with the product.
Modular could be only used in mobile or fix device, and could not be used in any
portable device.

PAGE 2 OF 1

Version 1.0