Caution :
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,there is no guarantee that
interference will not occur in a particular installation.If this equipment does cause harmful
interference to radio or television reception,which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Functions:
Bluetooth 2.0 specification compliant.
Support pairing and PIN code (Name: BTM10, Pin code:1234).
● Support Handfree, A2DP.Operations:Before using Bluetooth functions, you must connect
BTM10 with the unit. Connect BTM10 with the main unit by cable (reference Wiring
BTM10 Operation manual
Diagram
). then pair your mobile phone to the unit . Once the unit has been paired with your
phone, “BTM10” will be displayed on the mobile phone.
Answering an incoming call: To answer the call,pressthe“TALK”keyon the BTM10 box.
Hang up a received call: While talking, Press “TALK” key to finish the call.
Other operations depend on the unit and the remote control to actualize.
Wiring Diagram