HUIZHOU FORYOU GENERAL ELECTRONICS DV7B01 User Manual
DV7B01
DVD/CD/VCD/MP3/WMA/USB PLAYER
BLUETOOTH WITH FM/AM TUNER
Operation Instructions
Warnings
1. Only connect this unit to a 12V DC power
supply with negative grounding.
1
2. Never install this unit where the operation
for safety driving is restrained.
2
3. Never use the video display function in the
front when driving to prevent the violation
of laws & regulations and also to reduce
the risk of trafc accident except using the
rear view video camera.
3
5. Please don't change the fuse in the power
cord without professional guidance,
improper fuse may cause damage to this
using unit or even cause re.
5
6. Please power off this unit at once and send
it back to the after-sales service center or
the dealer / distributor you purchased from
if one of the following symptoms is found:
6
(a) No audio output;
(b) No image output;
(c) Water or other obstacle enters the unit;
(d) Smoking;
(e) Peculiar smell.
7. To ensure safe driving, please adjust the
volume to a safe and comfort level in case
of emergency situations.
4. Never expose this unit, amplier, speakers
to moisture or water to prevent electronic
sparks or res.
4
Precautions
1. Ne ve r di sa ss em ble or adjus t the uni t
wi tho ut an y pr of ess ion al gui de. F or
details, please consult any professional car
shop / dealer for inquiry.
2. If the front panel or TFT monitor is squalid,
pl ease us e a cl ea n silicone cloth and
neutr al deter gent to wipe off the spot.
Us ing a rou gh clot h and non- neu tr al
detergent such as alcohol for cleaning may
result in scratching or decoloration to the
applicant.
3. If any abnormal behavior of the unit is
found, please refer to tro ubl e shooting
gui de of this manu a l. If no rel e van t
in fo rm at io n is fou nd ,p le as e pre ss the
[RESET] key on the front panel to resume
factory default.
4. If you have parked the car in hot or cold
weather for a long time, please wait until
the temperature in the car becomes normal
before operating the unit.
5. Using in-car heater in low temperature
environment may result in beads coagulate
inside the unit, Do not use the unit in this
situation, eject the disc and wipe off the
bead on the disc. If the unit still doesn't
work after a few hours, please contact with
after-sales service center.
6. No erce impact to the LCD monitor when
it is in open position for preventing the
damage to any mechanisms inside.
7. To pr event th e damage to the screen ,
avoid touching it with sharp objects.
8. Th e mon it or employs au to motorizing
mec han ism, please don't push, pull, or
swi vel the monito r ma nua lly to prevent
damage to the core mechanism.
9. To provide a clear demonstration and an
alternative for easy understanding to the
operation of this unit, graphic illustrations
areused.However, these illustrations are
some different from the actual images
displayed on the screen.
10.During operating the unit, “ ” wil l
di sp la y if the curr en t ope ra ti on is n ot
available or illegal.
11.Operate the unit correctly according to this
manual to prevent unnecessary problem.
The guarantee won't be valid if the problem
is caused by inappropriate operation.
Declaration
This product incorporates copyright protection
technology that is protected by U.S patents
and other intellectual property rights. Use of
this copyright protection technology must be
authorized by Macrovision, and is intended
for home and other limited viewing uses only
unless otherwise authorized by Macrovision.
Re ver se e ng ineer ing or dis ass em bly is
prohibited.
Cautions of disc using
1. DO NOT use irregular shaped disc
2. Disc Cleaning
Use a dry, soft cloth to wipe the disc from
center to edge, only neutral detergent can
be used.
3. When playing a new disc
New di sc may have some rough spots
around the inner and outer edges. If such
a disc is used, remove these rough spots
with a pencil or ball-point pen, etc.
Contents
Before using
Front panel ............................................. 1
Remote Control ...................................... 2
Basic operations
Power on / off ......................................... 4
Audible beep conrmation ...................... 4
Mute ....................................................... 4
Open SOURCE MENU .......................... 4
Playing source selection ........................ 4
Volume adjustment ................................. 4
Using the TFT Monitor ........................... 4
System reset .......................................... 4
Change aspect ratio ............................... 4
Image settings ........................................ 4
Radio mode
Select radio as playing source ............... 5
Select one radio band ............................ 5
Tune ....................................................... 5
Manual tuning ......................................... 5
Preset station ......................................... 5
Search Stations Automatically ................ 5
EQ Selection .......................................... 5
Playback
Insert a disc ............................................ 6
Eject the disc .......................................... 6
Touch screen controls ............................ 6
Controlling Playback .............................. 6
Connect an USB Device ........................ 6
Play ........................................................ 6
Pause ..................................................... 6
Stop ........................................................ 6
Previous/Next ......................................... 6
Search for a Folder ................................ 6
Repeat playback .................................... 7
Repeat A-B ............................................. 7
Shufe (Random) Play ........................... 7
PBC function .......................................... 7
Select Audio Mode ................................. 7
Select Subtitle Language ....................... 7
Change Viewing Angle ........................... 7
Playback Information .............................. 8
For DVD ................................................. 8
For VCD ................................................. 8
Elapsed Time ......................................... 8
Direct Track Entry ................................... 8
Rotate Pictures ....................................... 8
Zoom ...................................................... 8
Other modes
Listen to Other Devices .......................... 9
Camera .................................................. 9
Steering Wheel Control Programming ... 9
Setup
Display System .................................... 10
Adjust General Settings ....................... 10
Adjust Video Settings ........................... 10
Adjust Time Settings .............................11
Adjust Audio settings .............................11
Adjust Language Settings .....................11
Adjust DVD Rating ............................... 12
Adjust Volume Settings ........................ 12
EQ
Select Preset Equalizer ........................ 13
Adjust EQ Parameters ......................... 13
Adjust FAD BAL .................................. 13
Troubleshooting ....................................... 13
Device connections
Notes of connection ........................... 16
Control Cables ..................................... 16
Region Code ....................................... 16
Parking Brake Cable Connections ..... 17
Reverse Driving Cable Connections .... 17
Installation and uninstall
Notes of installation .............................. 18
Installation procedures ......................... 18
Remove the unit .................................. 18
Trim ring installation ............................. 18
Trim ring uninstall ................................ 18
Specications ........................................... 19
Appendix
FCC Statement .................................... 20
FCC Radiation Exposure Statement .... 20
Wiring Diagram ......................................... 21
Before using
ཱི ུ ཱུ ྲྀ ཷ ླྀ ཹ ེ
Front panel
ཱ
ི
1. Disc slot
2. Reset the unit
3. [VOL /
4. [SRC] Key: Switch to the current source and the main menu
5. [
6. [TILT+] Knob: Increase the display angle
7. [OPEN/CLOSE] Key: Open / Close the TFT monitor
8. [TILT-] Knob: Decrease the display angle
9. [
10.USB Slot
11. AV IN jack
12.Eject disc
/
] Knob: Unit power / Adjust volume / Mute audio outputs
] Key: Auto search / Next / Move cursor to the right
] Key: Auto search / Previous / Move cursor to the left
ཻ
EN - 1
Before using
Remote Control
1. [SRC]Key:select playing source
2. [EJECT]Key: Eject disc
3. [AUDIO] Key: Select audio channel
4. [VOL+/-] Key: Adjust volume
5. [ZOOM] Key: Image zoom in/out
/BAND] Key: Select radio band / Fast
6. [
playback / Slow playback
7. [WIDE] Key: Change display mode
8. [PRESET / ] Key: Select preset radio
station
9. [EQ] Key: Enter/Exit the EQ setting
10.[GOTO] Key: GOTO search
11.[OPEN/CLOSE] Key: Open / Close the
TFT monitor
12.
[TILT / ] Key: Adjusting display tilting angle
13.[RPT A-B] Key: A-B repeat
14.[RPT] Key: Repeat playback
15.[MUTE] Key: Mute audio outputs
16.[POWER] Key: Unit power
17.[S UBTIT LE] Key: Select DVD sub title
language
18.[ANGLE] Key: Select view angle
19.[MENU] Key: DVD MENU / PBC
20.[TITLE] Key: DVD TITLE
21.[SETUP] Key: Setup menu
] Key: Fast Forward / Move cursor up
22.[
] Key: Aut o sear ch / N ext / Move
23.[
cursor to the right
24.[ ] Key: Play / Pause / Enter
25.[ ] Key:Auto search / Previous / Move
cursor to the left
26.[PIC] Key: Image setting
27.
[ ] Key: Fast Reverse/ Move cursor down
28.[ ] Key: Stop Playback
29.[DISP/CLEAR] Key: Display information /
Clear information
30.[0~9] Key: Numeric keys
31.[RDM] Key: Random playback
32.[INT] Key: Intro playback
Note:
Your remot e c ontr ol m ay diff er
slightly from the one pictured here.
The above diagram is for illustrative
purpose only.
EN - 2
Before using
Notes of remote control using
1) A im the re mo te control at the re mo te
sensor on the unit.
2) R emo ve t he bat ter y fr om t he rem ote
control or insert a battery insulator if the
battery has not been used for a month or
longer.
3) DO NOT store the remote control under
di re ct sunlight or in hig h tem pe ra tu re
env i ron m ent , o r i t m ay no t func t ion
properly.
4) The battery can work for 6 months under
normal condition. If the remote control can't
work, please change the battery.
5) U s e “bu t ton shap e d” li thi u m bat t ery
“CR2025” (3V) only.
6) DO NOT recharge, disassemble, heat or
expose the battery in re.
7) I nse rt t he b atter y in pro pe r direc tion
according to the (+) and (-) poles.
8) Store the battery in a place where children
cannot reach to avoid the risk of accident.
Uninstall Battery
Slide out the battery compartment
tray at the bottom on the back of the
remote control.
Install Battery
Use button-shaped lithium battery
“CR2 0 2 5 (3V) ” on ly. Inse r t the
battery to the battery tray with proper
direction according to the (+) and (-)
poles.
EN - 3
Basic operations
Power on / off
Press the [ ] key to turn the unit on. The
buttons on the front of the unit light up and
the current mode status appears on the LCD.
Press the [ ] key to power off the unit.
Audible beep conrmation
An audible beep tone conrms each function
selection. The Beep tone can be disabled
through the Setup menu.
Mute
Press the volume knob on the front panel or
press the [MUTE] key on the remote control
to mute the volume from the unit.
Open SOURCE MENU
Press the [SRC] key on the front panel or
remote control or touch the top left corner of
the screen to open the SOURCE MENU.
Do the above operation again to return to the
original source.
Playing source selection
Open the SOURCE MENU, and then touch
the source you desired or select one source
by moving the cursor and then conrm.
Volume adjustment
Volume Increase/Decrease
To increase or decrease the volume level,
turn the rotary encoder on the front panel.
When the volume level reaches "0" or "50", a
beep sounds, indicating that the adjustment
limit has bee n r eached. The TFT screen
displays the volume level for 3 seconds.
Programmable turn-on volume
This feature allows the user to select a turnon volume setting regardless of the volume
setting prior to turning the unit off. To program
a specic turn-on volume level, turn the rotary
encoder to adjust the volume to the desired
tur n-o n vo lume. Push and hold the rotary
encoder while the blue speaker icon and level
indication is displayed on the screen. The
unit will beep to conrm your turn-on volume
setting.
Using the TFT Monitor
Open / Close monitor
Press the [OPEN/CLOSE] key on the front
panel or remote control topush the display
panel out or in.
Change the monitor tilt angle
Due to the inherent character of LCD, you
will get different vision impressions when you
watch it from different angles.
The display angle of this unit can be changed;
hence you can select the best angle where
you can get the best vision impression.
Press the [TILT] key on the display panel or
the remote control to adjust the tilt angle one
step at a time.
Press and hold the [TILT] key on the display
panel or the remote control to adjust the tilt
angle continuously.
System reset
To correct a sys te m hal t or oth er illegal
operation, use the tip of a pen to press the
[RESET] key located on the panel. After a
system reset, the unit restores all factory
default settings.
Note:
If the unit is reset while a DVD is playing,
the DVD resum es play once the reset is
complete.
Change aspect ratio
Press the [WIDE] key on the remote control
to adjust the aspect ratio.
Image settings
1. Enter image setting mode
Press the [PIC] key on the remote control.
2. Select one item to adjust
Touch the [ ]/[ ] icon on the user
interface to adjust the value.
3. Exit image setting mode
To exit image setting mode, repeat the rst
step or stop operation for some seconds.
EN - 4
Loading...